Chapter 9. Keeping kernel panic parameters disabled in virtualized environments
When configuring a Virtual Machine in RHEL 9, you should not enable the softlockup_panic
and nmi_watchdog
kernel parameters, because the Virtual Machine might suffer from a spurious soft lockup. And that should not require a kernel panic.
Find the reasons behind this advice in the following sections.
9.1. What is a soft lockup
A soft lockup is a situation usually caused by a bug, when a task is executing in kernel space on a CPU without rescheduling. The task also does not allow any other task to execute on that particular CPU. As a result, a warning is displayed to a user through the system console. This problem is also referred to as the soft lockup firing.
Additional resources
9.2. Parameters controlling kernel panic
The following kernel parameters can be set to control a system’s behavior when a soft lockup is detected.
- softlockup_panic
Controls whether or not the kernel will panic when a soft lockup is detected.
Type Value Effect Integer
0
kernel does not panic on soft lockup
Integer
1
kernel panics on soft lockup
By default, on RHEL8 this value is 0.
The system needs to detect a hard lockup first to be able to panic. The detection is controlled by the
nmi_watchdog
parameter.- nmi_watchdog
Controls whether lockup detection mechanisms (
watchdogs
) are active or not. This parameter is of integer type.Value Effect 0
disables lockup detector
1
enables lockup detector
The hard lockup detector monitors each CPU for its ability to respond to interrupts.
- watchdog_thresh
Controls frequency of watchdog
hrtimer
, NMI events, and soft/hard lockup thresholds.Default threshold Soft lockup threshold 10 seconds
2 *
watchdog_thresh
Setting this parameter to zero disables lockup detection altogether.
Additional resources
9.3. Spurious soft lockups in virtualized environments
The soft lockup firing on physical hosts, as described in What is a soft lockup, usually represents a kernel or hardware bug. The same phenomenon happening on guest operating systems in virtualized environments may represent a false warning.
Heavy work-load on a host or high contention over some specific resource such as memory, usually causes a spurious soft lockup firing. This is because the host may schedule out the guest CPU for a period longer than 20 seconds. Then when the guest CPU is again scheduled to run on the host, it experiences a time jump which triggers due timers. The timers include also watchdog hrtimer
, which can consequently report a soft lockup on the guest CPU.
Because a soft lockup in a virtualized environment may be spurious, you should not enable the kernel parameters that would cause a system panic when a soft lockup is reported on a guest CPU.
To understand soft lockups in guests, it is essential to know that the host schedules the guest as a task, and the guest then schedules its own tasks.
Additional resources