Chapter 2. Start and Stop the Application Server
You need to start the JBoss Enterprise Application Platform instance for Fuse to run. This is because the Fuse components run on the JBoss Enterprise Application Platform container.
Fuse on JBoss EAP is not supported with Domain mode.
For more information about starting and stopping JBoss Enterprise Application Platform using alternative and more advanced methods, see the Red Hat JBoss Enterprise Application Platform Configuration Guide.
2.1. Start JBoss EAP 7.2
Start JBoss EAP 7.2 as a standalone server.
Start the Platform Service as a Standalone Server
For Red Hat Enterprise Linux:
Run the command:
EAP_HOME/bin/standalone.shFor Microsoft Windows Server:
Run the command:
EAP_HOME\bin\standalone.batOptionally specify additional parameters:
To print a list of additional parameters to pass to the start-up scripts, use the
-hparameter.
2.2. Stop JBoss EAP 7.2
Stop JBoss EAP using the Management CLI or by pressing CTRL+C in the terminal.
To stop JBoss EAP using the Management CLI:
Launch the Management CLI by running the
EAP_HOME/bin/jboss-cli.shcommand:$ EAP_HOME/bin/jboss-cli.sh
Connect to the server by running the
connectcommand:[disconnected /] connect
Stop the server by running the
shutdowncommand:[standalone@localhost:9999 /] shutdown
Close the Management CLI by running the
quitcommand:[standalone@localhost:9999 /] quit
To stop JBoss EAP by pressing CTRL+C:
- Navigate to the terminal where JBoss EAP is running.
- Press Ctrl+C to stop JBoss Enterprise Application Platform.
