Este contenido no está disponible en el idioma seleccionado.
4.3. Volume Group Administration
This section describes the commands that perform the various aspects of volume group administration.
4.3.1. Creating Volume Groups
To create a volume group from one or more physical volumes, use the
vgcreate command. The vgcreate command creates a new volume group by name and adds at least one physical volume to it.
The following command creates a volume group named
vg1 that contains physical volumes /dev/sdd1 and /dev/sde1.
vgcreate vg1 /dev/sdd1 /dev/sde1
When physical volumes are used to create a volume group, its disk space is divided into 4MB extents, by default. This extent is the minimum amount by which the logical volume may be increased or decreased in size. Large numbers of extents will have no impact on I/O performance of the logical volume.
You can specify the extent size with the
-s option to the vgcreate command if the default extent size is not suitable. You can put limits on the number of physical or logical volumes the volume group can have by using the -p and -l arguments of the vgcreate command.
By default, a volume group allocates physical extents according to common-sense rules such as not placing parallel stripes on the same physical volume. This is the
normal allocation policy. You can use the --alloc argument of the vgcreate command to specify an allocation policy of contiguous, anywhere, or cling.
The
contiguous policy requires that new extents are adjacent to existing extents. If there are sufficient free extents to satisfy an allocation request but a normal allocation policy would not use them, the anywhere allocation policy will, even if that reduces performance by placing two stripes on the same physical volume. The cling policy places new extents on the same physical volume as existing extents in the same stripe of the logical volume. These policies can be changed using the vgchange command.
In general, allocation policies other than
normal are required only in special cases where you need to specify unusual or nonstandard extent allocation.
LVM volume groups and underlying logical volumes are included in the device special file directory tree in the
/dev directory with the following layout:
/dev/vg/lv/
For example, if you create two volume groups
myvg1 and myvg2, each with three logical volumes named lvo1, lvo2, and lvo3, this create six device special files:
/dev/myvg1/lv01 /dev/myvg1/lv02 /dev/myvg1/lv03 /dev/myvg2/lv01 /dev/myvg2/lv02 /dev/myvg2/lv03
The maximum device size with LVM is 8 Exabytes on 64-bit CPUs.
