6.11. Cluster Resources Cleanup

If a resource has failed, a failure message appears when you display the cluster status. If you resolve that resource, you can clear that failure status with the pcs resource cleanup command. This command resets the resource status and failcount, telling the cluster to forget the operation history of a resource and re-detect its current state.

The following command cleans up the resource specified by resource_id.

pcs resource cleanup resource_id

pcs resource cleanup resource_id

If you do not specify a resource_id, this command resets the resource status and failcountfor all resources.

As of Red Hat Enterprise Linux 7.5, the pcs resource cleanup command probes only the resources that display as a failed action. To probe all resources on all nodes you can enter the following command:

pcs resource refresh

pcs resource refresh

By default, the pcs resource refresh command probes only the nodes where a resource's state is known. To probe all resources even if the state is not known, enter the following command:

pcs resource refresh --full

pcs resource refresh --full