このコンテンツは選択した言語では利用できません。
5.4. Configuring NFS Client Resources
This example procedure configures five NFS client resources for cluster
nfsclust. The procedure for configuring the first two clients only is laid out explicitly.
Use the following procedure to add NFS client resource
nfsclient1 to cluster nfsclust.
- At the Add a Resource page for cluster
nfsclust, click the drop-down box under and select - For , enter
nfsclient1. - For , enter
nfsclient1.example.com. This is the first NFS client system. - This field species additional client access rights. Specify
rw(read-write) in this field. For more information, refer to the General Options section of theexports(5) man page. - Check the checkbox. This indicates that if someone removes the export from the export list, the system will recover the export inline without taking down the NFS service.
- Click and accept the verification screen.
Use the following procedure to add NFS client resource
nfsclient2 to cluster nfsclust.
- At the Add a Resource page for cluster
nfsclust, click the drop-down box under and select - For , enter
nfsclient2. - For , enter
nfsclient2.example.com. This is the second NFS client system. - Leave the field blank.
- Check the checkbox.
- Click and accept the verification screen.
Use the same procedure to configure the remaining three NFS client resources, using
nfsclient3, nfsclient4, and nfsclient5 as the names of the resources and using nfsclient3.example.com, nfsclient4.example.com, and nfsclient5.example.com as the targets.