이 콘텐츠는 선택한 언어로 제공되지 않습니다.

6.4. Reverting to an ext2 File System


Because ext3 is relatively new, some disk utilities do not yet support it. For example, you may need to shrink a partition with resize2fs, which does not yet support ext3. In this situation, it may be necessary to temporarily revert a file system to ext2.
To revert a partition, you must first unmount the partition by logging in as root and typing,
umount /dev/mapper/VolGroup00-LogVol02
Next, change the file system type to ext2 by typing the following command as root:
 /sbin/tune2fs -O ^has_journal /dev/mapper/VolGroup00-LogVol02
Check the partition for errors by typing the following command as root:
/sbin/e2fsck -y /dev/mapper/VolGroup00-LogVol02
Then mount the partition again as ext2 file system by typing:
mount -t ext2 /dev/mapper/VolGroup00-LogVol02/mount/point
In the above command, replace /mount/point with the mount point of the partition.
Next, remove the .journal file at the root level of the partition by changing to the directory where it is mounted and typing:
rm -f .journal
You now have an ext2 partition.
If you want to permanently change the partition to ext2, remember to update the /etc/fstab file.

Note

You can increase the size of an ext3 file system using ext2online. ext2online allows you to increase the size of an ext3 file system once it is mounted (online) and on a resizable logical volume. The root file system is set up by default on LVM2 logical volumes during installation.
Note that ext2online will only work on ext3 file systems. For more information, refer to man ext2online.
Red Hat logoGithubredditYoutubeTwitter

자세한 정보

평가판, 구매 및 판매

커뮤니티

Red Hat 소개

Red Hat은 기업이 핵심 데이터 센터에서 네트워크 에지에 이르기까지 플랫폼과 환경 전반에서 더 쉽게 작업할 수 있도록 강화된 솔루션을 제공합니다.

보다 포괄적 수용을 위한 오픈 소스 용어 교체

Red Hat은 코드, 문서, 웹 속성에서 문제가 있는 언어를 교체하기 위해 최선을 다하고 있습니다. 자세한 내용은 다음을 참조하세요.Red Hat 블로그.

Red Hat 문서 정보

Legal Notice

Theme

© 2026 Red Hat
맨 위로 이동