이 콘텐츠는 선택한 언어로 제공되지 않습니다.
Chapter 3. Configuring an APC Switch as a Fence Device
This chapter provides the procedures for configuring an APC switch as a fence device in a Red Hat cluster using the Conga configuration tool.
Figure 3.1, “Using an APC Switch as a Fence Device” shows the configuration this procedure yields. In this configuration a three node cluster uses an APC switch as the fencing device. Each node in the cluster is connected to a port in the APC switch.
Figure 3.1. Using an APC Switch as a Fence Device
3.1. APC Fence Device Prerequisite Configuration 링크 복사링크가 클립보드에 복사되었습니다!
링크 복사링크가 클립보드에 복사되었습니다!
Table 3.1, “Configuration Prerequisities” summarizes the prerequisite components that have been set up before this procedure begins.
| Component | Name | Comment |
|---|---|---|
| cluster | apcclust | three-node cluster |
| cluster node | clusternode1.example.com | node in cluster apcclust configured with APC switch to administer power supply |
| cluster node | clusternode2.example.com | node in cluster apcclust configured with APC switch to administer power supply |
| cluster node | clusternode3.example.com | node in cluster apcclust configured with APC switch to administer power supply |
| IP address | 10.15.86.96 | IP address for the APC switch that controls the power for for clusternode1.example.com, clusternode2.example.com, and clusternode3.example.com |
| login | apclogin | login value for the APC switch that controls the power for for clusternode1.example.com, clusternode2.example.com, and clusternode3.example.com |
| password | apcpword | password for the APC switch that controls the power for for clusternode1.example.com, clusternode2.example.com, and clusternode3.example.com |
| port | 1 | port number on APC switch that clusternode1.example.com connects to |
| port | 2 | port number on APC switch that clusternode2.example.com connects to |
| port | 3 | port number on APC switch that clusternode3.example.com connects to |