이 콘텐츠는 선택한 언어로 제공되지 않습니다.

Chapter 2. Start and Stop the Application Server


You need to start the JBoss Enterprise Application Platform instance for Fuse to run. This is because the Fuse components run on the JBoss Enterprise Application Platform container.

Important

Fuse on JBoss EAP is not supported with Domain mode.

Note

For more information about starting and stopping JBoss Enterprise Application Platform using alternative and more advanced methods, see the Red Hat JBoss Enterprise Application Platform Configuration Guide.

2.1. Start JBoss EAP 7.2

Start JBoss EAP 7.2 as a standalone server.

Start the Platform Service as a Standalone Server

  • For Red Hat Enterprise Linux:

    Run the command: EAP_HOME/bin/standalone.sh

  • For Microsoft Windows Server:

    Run the command: EAP_HOME\bin\standalone.bat

  • Optionally specify additional parameters:

    To print a list of additional parameters to pass to the start-up scripts, use the -h parameter.

2.2. Stop JBoss EAP 7.2

Stop JBoss EAP using the Management CLI or by pressing CTRL+C in the terminal.

To stop JBoss EAP using the Management CLI:

  1. Launch the Management CLI by running the EAP_HOME/bin/jboss-cli.sh command:

    $ EAP_HOME/bin/jboss-cli.sh
  2. Connect to the server by running the connect command:

    [disconnected /] connect
  3. Stop the server by running the shutdown command:

    [standalone@localhost:9999 /] shutdown
  4. Close the Management CLI by running the quit command:

    [standalone@localhost:9999 /] quit

To stop JBoss EAP by pressing CTRL+C:

  1. Navigate to the terminal where JBoss EAP is running.
  2. Press Ctrl+C to stop JBoss Enterprise Application Platform.
Red Hat logoGithubRedditYoutubeTwitter

자세한 정보

평가판, 구매 및 판매

커뮤니티

Red Hat 소개

Red Hat은 기업이 핵심 데이터 센터에서 네트워크 에지에 이르기까지 플랫폼과 환경 전반에서 더 쉽게 작업할 수 있도록 강화된 솔루션을 제공합니다.

보다 포괄적 수용을 위한 오픈 소스 용어 교체

Red Hat은 코드, 문서, 웹 속성에서 문제가 있는 언어를 교체하기 위해 최선을 다하고 있습니다. 자세한 내용은 다음을 참조하세요.Red Hat 블로그.

Red Hat 문서 정보

Legal Notice

Theme

© 2026 Red Hat
맨 위로 이동