8장. Open vSwitch DPDK를 사용하여 LACP 결합 구성 및 테스트


참고

LACP를 사용한 OVS 본딩은 사용 중인 RHOSP(Red Hat OpenStack Platform) 버전에 따라 지원되지 않을 수 있습니다. 제품 설명서를 확인하여 LACP를 사용한 OVS 본딩이 지원되는지 확인합니다.

Open vSwitch DPDK를 사용하여 LACP 본딩을 구성하고 테스트하려면 다음 작업을 완료합니다.

  1. LACP의 스위치 포트를 구성합니다.
  2. LACP용 Linux 커널 본딩을 기준으로 구성합니다.
  3. LACP에 대해 OVS DPDK 본딩을 구성합니다.
참고

이 주제에서는 Dell S4048-ON 스위치를 사용한 스위치 구성에 대해 설명합니다. RHEL 및 OVS 구성은 동일하게 유지되지만 다른 스위치 벤더의 운영 체제는 다른 구문을 사용하여 LACP를 구성합니다.

8.1. LACP의 스위치 포트 구성

  1. 스위치 인터페이스를 기본 설정으로 재설정합니다.

    S4048-ON-sw#config t
    S4048-ON-sw(conf)#default int te1/2
    S4048-ON-sw(conf)#default int te1/7
    Copy to Clipboard Toggle word wrap
  2. 포트 채널 및 기타 포트 설정을 구성합니다.

    S4048-ON-sw(conf)#int range te1/2,te1/7
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7)#port-channel-protocol lacp
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7-lacp)#
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7-lacp)#port-channel 1 mode active
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7-lacp)#end
    S4048-ON-sw#config t
    S4048-ON-sw(conf)#int range te1/2,te1/7
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7)# no ip address
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7)# mtu 9216
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7)# flowcontrol rx on tx off
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7)# no shutdown
    S4048-ON-sw(conf-if-range-te-1/2,te-1/7)#end
    S4048-ON-sw#show run int te1/2
    !
    interface TenGigabitEthernet 1/2
     no ip address
     mtu 9216
     flowcontrol rx on tx off
    !
     port-channel-protocol LACP
      port-channel 1 mode active
     no shutdown
    Copy to Clipboard Toggle word wrap
  3. VLAN을 구성합니다.

    S4048-ON-sw#config t
    S4048-ON-sw(conf)#int range vlan901-909
    S4048-ON-sw(conf-if-range-vl-901-909)#tagged Port-channel 1
    S4048-ON-sw(conf-if-range-vl-901-909)#end
    S4048-ON-sw#
    Copy to Clipboard Toggle word wrap
  4. VLAN 태그를 확인합니다.

    S4048-ON-sw#show vlan id 902
    
    Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary, C - Community, I - Isolated
           O - Openflow, Vx - Vxlan
    Q: U - Untagged, T - Tagged
       x - Dot1x untagged, X - Dot1x tagged
       o - OpenFlow untagged, O - OpenFlow tagged
       G - GVRP tagged, M - Vlan-stack
       i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
    
        NUM    Status    Description                     Q Ports
        902    Active    Tenant                          T Po1()
                                                         T Te 1/1,1/3-1/6,1/8-1/20
    Copy to Clipboard Toggle word wrap
  5. LACP 구성을 확인합니다.

    S4048-ON-sw#show lacp 1
    Port-channel 1 admin up, oper down, mode lacp
    LACP Fast Switch-Over Disabled
    Actor   System ID:  Priority 32768, Address 1418.7789.9a8a
    Partner System ID:  Priority 0, Address 0000.0000.0000
    Actor Admin Key 1, Oper Key 1, Partner Oper Key 1, VLT Peer Oper Key 1
    LACP LAG 1 is an individual link
    
    LACP LAG 1 is a normal LAG
    
    A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
    E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
    I - Collection enabled, J - Collection disabled, K - Distribution enabled
    L - Distribution disabled, M - Partner Defaulted, N - Partner Non-defaulted,
    O - Receiver is in expired state, P - Receiver is not in expired state
    
    Port Te 1/2 is disabled, LACP is disabled and mode is lacp
    Port State: Not in Bundle
      Actor   Admin: State ACEHJLMP Key 1 Priority 32768
               Oper: State ACEHJLMP Key 1 Priority 32768
      Partner is not present
    
    Port Te 1/7 is enabled, LACP is enabled and mode is lacp
    Port State: Not in Bundle
      Actor   Admin: State ACEHJLMP Key 1 Priority 32768
               Oper: State ACEHJLMP Key 1 Priority 32768
      Partner is not present
    Copy to Clipboard Toggle word wrap
맨 위로 이동
Red Hat logoGithubredditYoutubeTwitter

자세한 정보

평가판, 구매 및 판매

커뮤니티

Red Hat 문서 정보

Red Hat을 사용하는 고객은 신뢰할 수 있는 콘텐츠가 포함된 제품과 서비스를 통해 혁신하고 목표를 달성할 수 있습니다. 최신 업데이트를 확인하세요.

보다 포괄적 수용을 위한 오픈 소스 용어 교체

Red Hat은 코드, 문서, 웹 속성에서 문제가 있는 언어를 교체하기 위해 최선을 다하고 있습니다. 자세한 내용은 다음을 참조하세요.Red Hat 블로그.

Red Hat 소개

Red Hat은 기업이 핵심 데이터 센터에서 네트워크 에지에 이르기까지 플랫폼과 환경 전반에서 더 쉽게 작업할 수 있도록 강화된 솔루션을 제공합니다.

Theme

© 2026 Red Hat