Red Hat Summit이 콘텐츠는 선택한 언어로 제공되지 않습니다.
Chapter 1. Prerequisites
Red Hat Enterprise Linux (RHEL) 9
- To obtain the latest version of Red Hat Enterprise Linux (RHEL) 9, see Download Red Hat Enterprise Linux.
- For installation instructions, see the Product Documentation for Red Hat Enterprise Linux 9.
- An active subscription to Red Hat
- Two or more virtual CPUs
- 4 GB or more of RAM
Approximately 30 GB of disk space on your test system, which can be broken down as follows:
- Approximately 10 GB of disk space for the Red Hat Enterprise Linux (RHEL) operating system.
- Approximately 10 GB of disk space for Docker storage for running three containers.
Approximately 10 GB of disk space for Red Hat Quay local storage.
NoteCEPH or other local storage might require more memory.
More information on sizing can be found at Quay 3.x Sizing Guidelines.
The following architectures are supported for Red Hat Quay:
- amd64/x86_64
- s390x
- ppc64le
1.1. Installing Podman
This document uses Podman for creating and deploying containers.
For more information on Podman and related technologies, see Building, running, and managing Linux containers on Red Hat Enterprise Linux 9.
If you do not have Podman installed on your system, the use of equivalent Docker commands might be possible, however this is not recommended. Docker has not been tested with Red Hat Quay 3.14, and will be deprecated in a future release. Podman is recommended for highly available, production quality deployments of Red Hat Quay 3.14.
Use the following procedure to install Podman.
Procedure
Enter the following command to install Podman:
$ sudo yum install -y podman
Alternatively, you can install the
container-toolsmodule, which pulls in the full set of container software packages:$ sudo yum module install -y container-tools
