Appendix B. RHEL 8 repositories
If your system is registered to the Red Hat Content Delivery Network (CDN) using the Red Hat Subscription Manager (RHSM), RHEL 8 repositories are automatically enabled during the in-place upgrade. However, on systems registered to Red Hat Satellite using RHSM, you must manually enable and synchronize both RHEL 7 and RHEL 8 repositories before running the pre-upgrade report.
Make sure to enable the target operating system (OS) version of each repository, for example RHEL 8.10. If you have enabled only the RHEL 8 version of the repositories, the in-place upgrade is inhibited.
If you plan to use Red Hat Satellite during the upgrade, you must enable and synchronize at least the following RHEL 8 repositories before the upgrade using either the Satellite web UI or the hammer repository-set enable and hammer product synchronize commands:
Replace <target_os_version> with the target operating system (OS) version, for example 8.10.
| Architecture | Repository | Repository ID | Repository name | Release version |
|---|---|---|---|---|
| 64-bit Intel | BaseOS |
| Red Hat Enterprise Linux 8 for x86_64 - BaseOS (RPMs) | x86_64 <target_os_version> |
| AppStream |
| Red Hat Enterprise Linux 8 for x86_64 - AppStream (RPMs) | x86_64 <target_os_version> | |
| IBM Power8 (little endian) | BaseOS |
| Red Hat Enterprise Linux 8 for Power, little endian - BaseOS (RPMs) | ppc64le <target_os_version> |
| AppStream |
| Red Hat Enterprise Linux 8 for Power, little endian - AppStream (RPMs) | ppc64le <target_os_version> | |
| IBM Z | BaseOS |
| Red Hat Enterprise Linux 8 for IBM z Systems - BaseOS (RPMs) | s390x <target_os_version> |
| AppStream |
| Red Hat Enterprise Linux 8 for IBM z Systems - AppStream (RPMs) | s390x <target_os_version> |
