此内容没有您所选择的语言版本。
7.2. Using iptables
The first step in using
iptables is to start the iptables service. This can be done with the command:
service iptables startWarning
The
ip6tables services should be turned off to use the iptables service with the following commands:
service ip6tables stopchkconfig ip6tables off
To make
iptables start by default whenever the system is booted, you must change runlevel status on the service using chkconfig.
chkconfig --level 345 iptables on
The syntax of
iptables is separated into tiers. The main tier is the chain. A chain specifies the state at which a packet is manipulated. The usage is as follows:
iptables -A chain -j target
The
-A option appends a rule at the end of an existing ruleset. The chain is the name of the chain for a rule. The three built-in chains of iptables (that is, the chains that affect every packet which traverses a network) are INPUT, OUTPUT, and FORWARD. These chains are permanent and cannot be deleted. The -j target option specifies the location in the iptables ruleset where this particular rule should jump. Some built in targets are ACCEPT, DROP, and REJECT.
New chains (also called user-defined chains) can be created by using the
-N option. Creating a new chain is useful for customizing granular or elaborate rules.
7.2.1. Basic Firewall Policies
Establishing basic firewall policies creates a foundation for building more detailed, user-defined rules.
iptables uses policies (-P) to create default rules. Security-minded administrators usually elect to drop all packets as a policy and only allow specific packets on a case-by-case basis. The following rules block all incoming and outgoing packets on a network gateway:
iptables -P INPUT DROPiptables -P OUTPUT DROP
Additionally, it is recommended that any forwarded packets — network traffic that is to be routed from the firewall to its destination node — be denied as well, to restrict internal clients from inadvertent exposure to the Internet. To do this, use the following rule:
iptables -P FORWARD DROP
After setting the policy chains, you can create new rules for your particular network and security requirements. The following sections outline some rules you may implement in the course of building your
iptables firewall.
