Appendix B. RHEL 10 repositories
If your system is registered to the Red Hat Content Delivery Network (CDN) by using the Red Hat Subscription Manager (RHSM), RHEL 10 repositories are automatically enabled during the in-place upgrade. However, on systems registered to Red Hat Satellite by using RHSM, you must manually enable and synchronize both RHEL 9 and RHEL 10 repositories before running the pre-upgrade report.
Make sure to enable the target OS version of each repository, for example 10.0. If you have enabled only the RHEL 10 version of the repositories, the in-place upgrade is inhibited.
If you plan to use Red Hat Satellite during the upgrade, you must enable and synchronize at least the following RHEL 10 repositories before the upgrade by using either the Satellite web UI or the hammer repository-set enable
and hammer product synchronize
commands:
Architecture | Repository | Repository ID | Repository name | Release version |
---|---|---|---|---|
64-bit Intel and AMD | BaseOS |
| Red Hat Enterprise Linux 10 for x86_64 - BaseOS (RPMs) | x86_64 <target_os_version> |
AppStream |
| Red Hat Enterprise Linux 10 for x86_64 - AppStream (RPMs) | x86_64 <target_os_version> | |
64-bit ARM | BaseOS |
| Red Hat Enterprise Linux 10 for ARM 64 - BaseOS (RPMs) | aarch64 <target_os_version> |
AppStream |
| Red Hat Enterprise Linux 10 for ARM 64 - AppStream (RPMs) | aarch64 <target_os_version> | |
IBM Power (little endian) | BaseOS |
| Red Hat Enterprise Linux 10 for Power, little endian - BaseOS (RPMs) | ppc64le <target_os_version> |
AppStream |
| Red Hat Enterprise Linux 10 for Power, little endian - AppStream (RPMs) | ppc64le <target_os_version> | |
IBM Z | BaseOS |
| Red Hat Enterprise Linux 10 for IBM z Systems - BaseOS (RPMs) | s390x <target_os_version> |
AppStream |
| Red Hat Enterprise Linux 10 for IBM z Systems - AppStream (RPMs) | s390x <target_os_version> |
Replace <target_os_version> with the target OS version, for example 10.0
.