4.6. Growing a File System
The
gfs2_grow command is used to expand a GFS2 file system after the device where the file system resides has been expanded. Running a gfs2_grow command on an existing GFS2 file system fills all spare space between the current end of the file system and the end of the device with a newly initialized GFS2 file system extension. When the fill operation is completed, the resource index for the file system is updated. All nodes in the cluster can then use the extra storage space that has been added.
Warning
A regression was found in
kernel-2.6.32-754.el6 that can cause the gfs2_grow command to fail and potentially cause GFS2 metadata corruption. Before running the gfs2_grow command, ensure that you update to kernel-2.6.32-754.6.3.el6.
The
gfs2_grow command must be run on a mounted file system, but only needs to be run on one node in a cluster. All the other nodes sense that the expansion has occurred and automatically start using the new space.
Note
Once you have created a GFS2 file system with the
mkfs.gfs2 command, you cannot decrease the size of the file system.
Usage
gfs2_grow MountPointMountPoint- Specifies the GFS2 file system to which the actions apply.
Comments
Before running the
gfs2_grow command:
- Back up important data on the file system.
- Determine the volume that is used by the file system to be expanded by running a
dfcommand.MountPoint - Expand the underlying cluster volume with LVM. For information on administering LVM volumes, see Logical Volume Manager Administration.
After running the
gfs2_grow command, run a df command to check that the new space is now available in the file system.
Examples
In this example, the file system on the
/mygfs2fs directory is expanded.
[root@dash-01 ~]# gfs2_grow /mygfs2fs
FS: Mount Point: /mygfs2fs
FS: Device: /dev/mapper/gfs2testvg-gfs2testlv
FS: Size: 524288 (0x80000)
FS: RG size: 65533 (0xfffd)
DEV: Size: 655360 (0xa0000)
The file system grew by 512MB.
gfs2_grow complete.
Complete Usage
gfs2_grow [Options] {MountPoint|Device} [MountPoint|Device]
MountPoint- Specifies the directory where the GFS2 file system is mounted.
Device- Specifies the device node of the file system.
Table 4.3, “GFS2-specific Options Available While Expanding A File System” describes the GFS2-specific options that can be used while expanding a GFS2 file system.
| Option | Description |
|---|---|
-h | Help. Displays a short usage message. |
-q | Quiet. Turns down the verbosity level. |
-r MegaBytes | Specifies the size of the new resource group. The default size is 256MB. |
-T | Test. Do all calculations, but do not write any data to the disk and do not expand the file system. |
-V | Displays command version information. |
