B.3. How to Set Up Red Hat Enterprise Virtualization Manager to Use FCoE
You can configure Fibre Channel over Ethernet (FCoE) properties for host network interface cards from the Administration Portal. The
key is not available by default and needs to be added to the Manager using the engine configuration tool. You can check whether has already been enabled by running the following command:
# engine-config -g UserDefinedNetworkCustomProperties
You also need to install the required VDSM hook package on the hosts. Depending on the FCoE card on the hosts, special configuration may also be needed; see Configuring a Fibre Channel over Ethernet Interface in the Red Hat Enterprise Linux Storage Administration Guide.
Procedure B.2. Adding the fcoe Key to the Manager
- On the Manager, run the following command to add the key:
# engine-config -s UserDefinedNetworkCustomProperties='fcoe=^((enable|dcb|auto_vlan)=(yes|no),?)*$'
- Restart the
ovirt-engine
service:# service ovirt-engine restart
- Install the VDSM hook package on each of the Red Hat Enterprise Linux hosts on which you want to configure FCoE properties. The package is available by default on Red Hat Enterprise Virtualization Hypervisors.
# yum install vdsm-hook-fcoe
The Section 5.5.2, “Editing Host Network Interfaces and Assigning Logical Networks to Hosts” to apply FCoE properties to logical networks.
key is now available in the Administration Portal. See