Este contenido no está disponible en el idioma seleccionado.
2.5. Testing the Resource Configuration
In the cluster status display shown in Section 2.4, “Creating the Resources and Resource Groups with the pcs Command”, all of the resources are running on node
z1.example.com. You can test whether the resource group fails over to node z2.example.com by using the following procedure to put the first node in standby mode, after which the node will no longer be able to host resources.
- The following command puts node
z1.example.cominstandbymode.root@z1 ~]#
pcs node standby z1.example.com - After putting node
z1in standby mode, check the cluster status. Note that the resources should now all be running onz2.[root@z1 ~]#
pcs statusCluster name: my_cluster Last updated: Wed Jul 31 17:16:17 2013 Last change: Wed Jul 31 17:18:34 2013 via crm_attribute on z1.example.com Stack: corosync Current DC: z2.example.com (2) - partition with quorum Version: 1.1.10-5.el7-9abe687 2 Nodes configured 6 Resources configured Node z1.example.com (1): standby Online: [ z2.example.com ] Full list of resources: myapc (stonith:fence_apc_snmp): Started z1.example.com Resource Group: apachegroup my_lvm (ocf::heartbeat:LVM): Started z2.example.com my_fs (ocf::heartbeat:Filesystem): Started z2.example.com VirtualIP (ocf::heartbeat:IPaddr2): Started z2.example.com Website (ocf::heartbeat:apache): Started z2.example.comThe web site at the defined IP address should still display, without interruption. - To remove
z1fromstandbymode, enter the following command.root@z1 ~]#
pcs node unstandby z1.example.comNote
Removing a node fromstandbymode does not in itself cause the resources to fail back over to that node. This will depend on theresource-stickinessvalue for the resources. For information on theresource-stickinessmeta attribute, see Configuring a Resource to Prefer its Current Node in the Red Hat High Availability Add-On Reference.
