Este contenido no está disponible en el idioma seleccionado.
Chapter 2. Configuring the Fujitsu ETERNUS device
Configure storage pools and ports on the device before you define the Fujitsu ETERNUS device as a Block Storage back end. Consult your device documentation for details on each step:
Procedure
- Configure a LAN connection between the Controller nodes that host the Block Storage service and the MNT ports of the ETERNUS device.
- Configure a SAN connection between the Compute nodes and CA ports of the ETERNUS device.
-
Log in to the ETERNUS device using an account with the
Adminrole. - Enable the SMI-S of ETERNUS DX.
- Set the SSH key
-
Add a user account with
softwarerole. -
Register an
Advanced Copy Featurelicense and configure the copy table size. -
Create a storage pool for volumes. You use this pool later in the
EternusPoolsetting in Section 3.1, “Creating driver definitions for each Fujitsu ETERNUS back end”. -
Optional: Create a separate storage pool for volume snapshots. This pool represents the
EternusSnapPoolsetting in Section 3.1, “Creating driver definitions for each Fujitsu ETERNUS back end”. Optional: Create a
Snap Data Pool Volume (SDPV)to enable Snap Data Pool (SDP) for thecreate a snapshotfunction.TipSkip this step if you use a Thin Provision Pool for
EternusSnapPool.-
Configure
storage portsto be used by the Block Storage service. -
Set the
storage portsports toCAmode. To enable
host-affinityfor the storage ports, enter the following command from the ETERNUS CLI for each port:set <PROTO>-parameters -host-affinity enable -port <CM#> <CA#> <PORT>
set <PROTO>-parameters -host-affinity enable -port <CM#> <CA#> <PORT>Copy to Clipboard Copied! Toggle word wrap Toggle overflow -
Replace <PROTO> with the storage protocol, such as
fcoriscsi. - Replace <CM#> and <CA#> with the name of the controller enclosure where the port is located.
- Replace <PORT> with the port number.
-
Replace <PROTO> with the storage protocol, such as
Use the following commands to generate the SSH key on the undercloud, and upload the
eternus.ietffile to the ETERNUS device.ssh-keygen -t rsa -N "" -f ./eternus ssh-keygen -e -f ./eternus.pub > ./eternus.ietf
ssh-keygen -t rsa -N "" -f ./eternus ssh-keygen -e -f ./eternus.pub > ./eternus.ietfCopy to Clipboard Copied! Toggle word wrap Toggle overflow NoteSave the
eternusfile for later use. For security reasons, do not copy or move it from the undercloud or overcloud.