Este contenido no está disponible en el idioma seleccionado.
Chapter 2. Requirements and your responsibilities
Review the hardware and software requirements and your responsibilities before you use the service.
2.1. Requirements Copiar enlaceEnlace copiado en el portapapeles!
To begin using simple content access, you must meet the following software requirements.
For simple content access with Red Hat Subscription Management:
- Simple content access enabled within Red Hat Subscription Management.
For simple content access with Red Hat Satellite:
Satellite 6.14 or later (versions that are under full or maintenance support). Earlier versions of Satellite can be used with simple content access, but migration to a supported version of Satellite is recommended.
NoteFor Satellite version support information, see the Red Hat Satellite Product Life Cycle life cycle and update policy document.
Simple content access enabled, where required.
- Satellite version 6.16 supports only simple content access. Manual enablement of simple content access is not required for versions 6.16 and later.
- Satellite versions 6.15 and 6.14 (and 6.13, reaching end of life (EOL) in November 2024), simple content access enabled for each Satellite organization. Any simple content access setting on the manifest is ignored; the setting on the Satellite organization takes precedence.
- Satellite versions 6.12 and earlier (EOL versions that are not supported), simple content access enabled for each allocation and manifest. In addition, enabled manifests must be refreshed for simple content access to take effect.
2.2. Your responsibilities Copiar enlaceEnlace copiado en el portapapeles!
As you use simple content access, note the following agreements and contractual responsibilities that remain in effect:
Simple content access does not eliminate any contractual requirements between you and Red Hat. You are still required to ensure that your deployments are in accordance with any Red Hat contracts.