Chapter 2. Setting up RPM packaging workspace

To build RPM packages, you must first create a special workspace that consists of directories used for different packaging purposes.

2.1. Configuring RPM packaging workspace
Copier lien

Prepare your environment for software packaging by setting up an RPM packaging workspace.

To configure the RPM packaging workspace, you can set up a directory layout by using the rpmdev-setuptree utility.

Prerequisites

You installed the rpmdevtools package, which provides utilities for packaging RPMs:
```
# dnf install rpmdevtools
```

Procedure

Set up packaging workspace directories:

$ tree ~/rpmbuild/

/home/user/rpmbuild/
|-- BUILD
|-- RPMS
|-- SOURCES
|-- SPECS
`-- SRPMS

5 directories, 0 files

Review the following directories that the rpmdev-setuptree utility creates to set up the RPM packaging workspace.

Expand

Table 2.1. RPM packaging workspace directories
Directory	Purpose
`BUILD`	Contains build artifacts compiled from the source files from the `SOURCES` directory.
`RPMS`	Binary RPMs are created under the `RPMS` directory in subdirectories for different architectures. For example, in the `x86_64` or `noarch` subdirectory.
`SOURCES`	Contains compressed source code archives and patches. The `rpmbuild` command then searches for these archives and patches in this directory.
`SPECS`	Contains `spec` files created by the packager. These files are then used for building packages.
`SRPMS`	When you use the `rpmbuild` command to build an SRPM instead of a binary RPM, the resulting SRPM is created under this directory.