Questo contenuto non è disponibile nella lingua selezionata.

Chapter 9. Fail over to the secondary site


This chapter describes the steps to fail over from primary site to secondary site in a setup as outlined in Concepts for active-passive deployments together with the blueprints outlined in Building blocks active-passive deployments.

9.1. When to use procedure

A failover from the primary site to the secondary site will happen automatically based on the checks configured in the loadbalancer.

When the primary site loses its state in Data Grid or a network partition occurs that prevents the synchronization, manual procedures are necessary to recover the primary site before it can handle traffic again, see the Switch back to the primary site chapter.

To prevent an automatic fallback to the primary site before those manual steps have been performed, configure the loadbalancer as described following to prevent this from happening automatically.

For a graceful switch to the secondary site, follow the instructions in the Switch over to the secondary site chapter.

See the Multi-site deployments chapter for different operational procedures.

9.2. Procedure

Follow these steps to manually force a failover.

9.2.1. Route53

To force Route53 to mark the primary site as permanently not available and prevent an automatic fallback, edit the health check in AWS to point to a non-existent route (health/down).

Red Hat logoGithubredditYoutubeTwitter

Formazione

Prova, acquista e vendi

Community

Informazioni sulla documentazione di Red Hat

Aiutiamo gli utenti Red Hat a innovarsi e raggiungere i propri obiettivi con i nostri prodotti e servizi grazie a contenuti di cui possono fidarsi. Esplora i nostri ultimi aggiornamenti.

Rendiamo l’open source più inclusivo

Red Hat si impegna a sostituire il linguaggio problematico nel codice, nella documentazione e nelle proprietà web. Per maggiori dettagli, visita il Blog di Red Hat.

Informazioni su Red Hat

Forniamo soluzioni consolidate che rendono più semplice per le aziende lavorare su piattaforme e ambienti diversi, dal datacenter centrale all'edge della rete.

Theme

© 2026 Red Hat
Torna in cima