이 콘텐츠는 선택한 언어로 제공되지 않습니다.

18.5. Idle Connections


You can configure connections to be closed when they are idle. For example; if you just had a peak period and now want to reap the unused ones. This is done via the idle-timeout-minutes parameter.
Idle checking is done on a separate Idle Remover thread on an 'least recently used' (LRU) basis.
Idle connections (connections that have been unused for the period defined by idle-timeout-minutes) are purged regularly. The check is performed at an interval that is half of the idle-timeout-minutes value.
The pool itself operates on an 'most recently used' (MRU) basis. This allows the excess connections to be easily identified.
Should closing idle connections cause the pool to fall below the min-pool-size value, new connections are created.

Note

If you have long-running transactions and you use interleaving (i.e. do not track-connection-by-tx) make sure the idle timeout is greater than the transaction timeout. When interleaving the connection is returned to the pool for others to use. If however nobody does use it, it would be a candidate for removal before the transaction is committed.
맨 위로 이동
Red Hat logoGithubredditYoutubeTwitter

자세한 정보

평가판, 구매 및 판매

커뮤니티

Red Hat 문서 정보

Red Hat을 사용하는 고객은 신뢰할 수 있는 콘텐츠가 포함된 제품과 서비스를 통해 혁신하고 목표를 달성할 수 있습니다. 최신 업데이트를 확인하세요.

보다 포괄적 수용을 위한 오픈 소스 용어 교체

Red Hat은 코드, 문서, 웹 속성에서 문제가 있는 언어를 교체하기 위해 최선을 다하고 있습니다. 자세한 내용은 다음을 참조하세요.Red Hat 블로그.

Red Hat 소개

Red Hat은 기업이 핵심 데이터 센터에서 네트워크 에지에 이르기까지 플랫폼과 환경 전반에서 더 쉽게 작업할 수 있도록 강화된 솔루션을 제공합니다.

Theme

© 2025 Red Hat