5.8. Configure higher VM workload density


You can increase the number of virtual machines (VMs) on nodes by overcommitting memory (RAM). You overcommit memory by provisioning swap storage on worker nodes. This is useful when you have many similar or underused workloads.

참고

Memory overcommitment can lower workload performance on a highly utilized system.

5.8.1. Swap provisioning methods

You can provision swap storage on worker nodes by using either an NVMe partition or a file-based approach. The method you choose depends on your hardware configuration and performance requirements.

NVMe partition-based swap requires a dedicated NVMe device on each worker node and provides better performance for production workloads with heavy memory overcommitment. This method is permanent and requires repartitioning to remove.

File-based swap uses existing filesystem space and works on any worker node without dedicated hardware. This method has slower I/O performance than partition-based swap but is easier to provision and remove. Use this method for testing, development, or production clusters where dedicated NVMe devices are not available.

Red Hat logoGithubRedditYoutubeTwitter

자세한 정보

평가판, 구매 및 판매

커뮤니티

Red Hat 소개

Red Hat은 기업이 핵심 데이터 센터에서 네트워크 에지에 이르기까지 플랫폼과 환경 전반에서 더 쉽게 작업할 수 있도록 강화된 솔루션을 제공합니다.

보다 포괄적 수용을 위한 오픈 소스 용어 교체

Red Hat은 코드, 문서, 웹 속성에서 문제가 있는 언어를 교체하기 위해 최선을 다하고 있습니다. 자세한 내용은 다음을 참조하세요.Red Hat 블로그.

Red Hat 문서 정보

Legal Notice

Theme

© 2026 Red Hat
맨 위로 이동