이 콘텐츠는 선택한 언어로 제공되지 않습니다.

2.7. device-mapper-multipath


The device-mapper-multipath packages provide tools to manage multipath devices using the device-mapper multipath kernel module.
  • Note that under certain circumstances, the multipathd daemon can terminate unexpectedly during shutdown.
  • It is possible to overwrite the default hardware table. However, regular expression matches are not allowed; the vendor and product strings need to be matched exactly. These strings can be found by running the following command:
    ~]# multipathd -k"show config"
    
  • By default, the multipathd service starts up before the iscsi service. This provides multipathing support early in the bootup process and is necessary for multipathed iSCSI SAN boot setups. However, once started, the multipathd service adds paths as informed about them by udev. As soon as the multipathd service detects a path that belongs to a multipath device, it creates the device. If the first path that multipathd notices is a passive path, it attempts to make that path active. If it later adds a more optimal path, multipathd activates the more optimal path. In some cases, this can cause a significant overhead during a startup.
    If you are experiencing such performance problems, define the multipathd service to start after the iscsi service. This does not apply to systems where the root device is a multipathed iSCSI device, since it the system would become unbootable. To move the service start time run the following commands:
    ~]# mv /etc/rc5.d/S06multipathd /etc/rc5.d/S14multipathd
    ~]# mv /etc/rc3.d/S06multipathd /etc/rc3.d/S14multipathd
    To restore the original start time, run the following command:
    ~]# chkconfig multipathd resetpriorities
    (BZ#500998)
  • Running the multipath command with the -ll option can cause the command to hang if one of the paths is on a blocking device. Note that the driver does not fail a request after some time if the device does not respond.
    This is caused by the cleanup code, which waits until the path checker request either completes or fails. To display the current multipath state without hanging the command, use multipath -l instead. (BZ#214838)
Red Hat logoGithubRedditYoutubeTwitter

자세한 정보

평가판, 구매 및 판매

커뮤니티

Red Hat 문서 정보

Red Hat을 사용하는 고객은 신뢰할 수 있는 콘텐츠가 포함된 제품과 서비스를 통해 혁신하고 목표를 달성할 수 있습니다.

보다 포괄적 수용을 위한 오픈 소스 용어 교체

Red Hat은 코드, 문서, 웹 속성에서 문제가 있는 언어를 교체하기 위해 최선을 다하고 있습니다. 자세한 내용은 다음을 참조하세요.Red Hat 블로그.

Red Hat 소개

Red Hat은 기업이 핵심 데이터 센터에서 네트워크 에지에 이르기까지 플랫폼과 환경 전반에서 더 쉽게 작업할 수 있도록 강화된 솔루션을 제공합니다.

© 2024 Red Hat, Inc.