이 콘텐츠는 선택한 언어로 제공되지 않습니다.

Chapter 5. BPMN2 subprocesses in process designer

A subprocess is an activity that contains nodes. You can embed part of the main process within a subprocess. You can also include variable definitions within the the subprocess. These variables are accessible to all nodes inside the subprocess.

A subprocess must have one incoming connection and one outgoing connection. If you use a terminate end event inside a subprocess, the entire process instance that contains the subprocess is terminated, not just the subprocess. A subprocess ends when there are no more active elements in it.

The following subprocess types are supported in Red Hat Process Automation Manager:

Embedded subprocess, which is a part of the parent process execution and shares its data
ad hoc subprocess, which has no strict element execution order
Reusable subprocess, which is independent from its parent process
Event subprocess, which is only triggered on a start event or a timer
Multi-instance subprocess

In the following example, the Place Order subprocess checks whether sufficient stock is available to place the order and updates the stock information if the order can be placed. The customer is then notified through the main process based on whether or not the order was placed.

subprocess

Embedded subprocess

An embedded subprocess encapsulates a part of the process. It must contain a start event and at least one end event. Note that the element enables you to define local subprocess variables that are accessible to all elements inside this container.

AdHoc subprocess

An ad hoc subprocess or process contains a number of embedded inner activities and is intended to be executed with a more flexible ordering compared to the typical routing of processes. Unlike regular processes, an ad hoc subprocess does not contain a complete, structured BPMN2 diagram description, for example, from start event to end event. Instead, the ad hoc subprocess contains only activities, sequence flows, gateways, and intermediate events. An ad hoc subprocess can also contain data objects and data associations. The activities within the ad hoc subprocesses are not required to have incoming and outgoing sequence flows. However, you can specify sequence flows between some of the contained activities. When used, sequence flows provide the same ordering constraints as in a regular process. To have any meaning, intermediate events must have outgoing sequence flows and they can be triggered multiple times while the ad hoc subprocess is active.

Reusable subprocess

Reusable subprocesses appear collapsed within the containing process, and the subprocesses elements are not visible until you click a plus sign at the lower edge of the rounded rectangle.

Event subprocess

An event subprocess becomes active when its start event is triggered. It can interrupt the parent process context or run in parallel with it.

With no outgoing or incoming connections, only an event or a timer can trigger the subprocess. The subprocess is not part of the regular control flow. Although self-contained, it is executed in the context of the bounding process.

Use an event subprocess within a process flow to handle events that happen outside of the main process flow. For example, while booking a flight, two events may occur:

Cancel booking (interrupting)
Check booking status (non-interrupting)

You can model both of these events using the event subprocess.

Multiple instance subprocess

A multiple instances subprocess is instantiated multiple times when its execution is triggered. The instances are created sequentially. A new subprocess instance is created only after the previous instance has finished.

A multiple instances subprocess has one incoming connection and one outgoing connection.

이 콘텐츠는 선택한 언어로 제공되지 않습니다.

Chapter 5. BPMN2 subprocesses in process designer

자세한 정보

평가판, 구매 및 판매

커뮤니티

Red Hat 문서 정보

보다 포괄적 수용을 위한 오픈 소스 용어 교체

Red Hat 소개

Theme

Red Hat legal and privacy links

Red Hat legal and privacy links