Este conteúdo não está disponível no idioma selecionado.
4.2.2. Displaying Physical Volumes
				There are three commands you can use to display properties of LVM physical volumes: 
pvs, pvdisplay, and pvscan.
			
				The 
pvs command provides physical volume information in a configurable form, displaying one line per physical volume. The pvs command provides a great deal of format control, and is useful for scripting. For information on using the pvs command to customize your output, see Section 4.9, “Customized Reporting for LVM”.
			
				The 
pvdisplay command provides a verbose multi-line output for each physical volume. It displays physical properties (size, extents, volume group, etc.) in a fixed format.
			
				The following example shows the output of the 
pvdisplay command for a single physical volume.
			
				The 
pvscan command scans all supported LVM block devices in the system for physical volumes.
			
				The following command shows all physical devices found:
			
				You can define a filter in the 
lvm.conf so that this command will avoid scanning specific physical volumes. For information on using filters to control which devices are scanned, see Section 4.6, “Controlling LVM Device Scans with Filters”.