B.3. How to Set Up Red Hat Virtualization Manager to Use FCoE

You can configure Fibre Channel over Ethernet (FCoE) properties for host network interface cards from the Administration Portal. The fcoe key is not available by default and needs to be added to the Manager using the engine configuration tool. You can check whether fcoe has already been enabled by running the following command:

engine-config -g UserDefinedNetworkCustomProperties

# engine-config -g UserDefinedNetworkCustomProperties

You also need to install the required VDSM hook package on the hosts. Depending on the FCoE card on the hosts, special configuration may also be needed; see Configuring a Fibre Channel over Ethernet Interface in the Red Hat Enterprise Linux Storage Administration Guide.

Adding the fcoe Key to the Manager

The fcoe key is now available in the Administration Portal. See Section 6.4.2, “Editing Host Network Interfaces and Assigning Logical Networks to Hosts” to apply FCoE properties to logical networks.