Este conteúdo não está disponível no idioma selecionado.
6.2.3. Gear Capacity Planning
Districts and nodes have separate capacity limits for the number of gears allowed on each. Districts allocate UIDs from a fixed pool and can only contain 6000 gears, regardless of their state. Nodes, however, only constrain the number of active gears on that host.
6.2.3.1. Gear Capacity Planning for Nodes
Use the
max_active_gears parameter in the /etc/openshift/resource_limits.conf file to specify the maximum number of active gears allowed per node. By default, this value is set to 100, but most administrators will need to modify this value over time. Stopped or idled gears do not count toward this limit; a node can have any number of inactive gears, constrained only by storage. However, starting inactive gears after the max_active_gears limit has been reached may exceed the limit, which cannot be prevented or corrected. Reaching the limit exempts the node from future gear placement by the broker.
The safest way to calculate the
max_active_gears limit on nodes is to consider the resource most likely to be exhausted first (typically RAM) and divide the amount of available resource by the resource limit per gear. For example, consider a node with 7.5 GB of RAM available and gears constrained to 0.5 GB of RAM:
Example 6.1. Example max_active_gears Calculation
max_active_gears = 7.5 GB / 0.5 GB = 15 gears
Most gears do not consume their entire resource quota, so this conservative limit can leave some resources unused. Most administrators should overcommit at least some of their nodes by allowing more gears than would fit if all gears used all of their resources. Experimentation is recommended to discover optimal settings for your OpenShift Enterprise deployment. Based on the types of cartridges and applications expected, as well as the amount of scarce resources actually used (such as RAM, CPU, network bandwidth, processes, inodes, etc.), determine an overcommit percent by which to increase your limits.
Changing the
max_active_gears parameter after installation is harmless. Consider beginning with conservative limits and adjust accordingly after empirical evidence of usage becomes available. It is easier to add more active gears than to move them away.
