Este conteúdo não está disponível no idioma selecionado.
Chapter 3. Getting Started
This chapter describes procedures for initial setup of GFS2 and contains the following sections:
3.1. Prerequisite Tasks
You should complete the following tasks before setting up Red Hat GFS2:
- Make sure that you have noted the key characteristics of the GFS2 nodes (refer to Section 2.1, “Before Setting Up GFS2”).
- Make sure that the clocks on the GFS2 nodes are synchronized. It is recommended that you use the Network Time Protocol (NTP) software provided with your Red Hat Enterprise Linux distribution.
Note
The system clocks in GFS2 nodes must be within a few minutes of each other to prevent unnecessary inode time-stamp updating. Unnecessary inode time-stamp updating severely impacts cluster performance. - In order to use GFS2 in a clustered environment, you must configure your system to use the Clustered Logical Volume Manager (CLVM), a set of clustering extensions to the LVM Logical Volume Manager. In order to use CLVM, the Red Hat Cluster Suite software, including the
clvmddaemon, must be running. For information on using CLVM, see Logical Volume Manager Administration. For information on installing and administering Red Hat Cluster Suite, see Cluster Administration.
