Este conteúdo não está disponível no idioma selecionado.
35.2. Configuring an iface for Software iSCSI
As mentioned earlier, an
iface configuration is required for each network object that will be used to bind a session.
Before
To create an
iface configuration for software iSCSI, run the following command:
# iscsiadm -m iface -I iface_name --op=new
This will create a new empty
iface configuration with a specified iface_name. If an existing iface configuration already has the same iface_name, then it will be overwritten with a new, empty one.
To configure a specific setting of an
iface configuration, use the following command:
# iscsiadm -m iface -I iface_name --op=update -n iface.setting -v hw_address
Example 35.4. Set MAC address of iface0
For example, to set the MAC address (
hardware_address) of iface0 to 00:0F:1F:92:6B:BF, run:
# iscsiadm -m iface -I iface0 --op=update -n iface.hwaddress -v 00:0F:1F:92:6B:BF
Warning
Do not use
default or iser as iface names. Both strings are special values used by iscsiadm for backward compatibility. Any manually-created iface configurations named default or iser will disable backwards compatibility.
