1.12.  Logging In to an iSCSI Target

As mentioned in Section 1.2, “iSCSI”, the iSCSI service must be running in order to discover or log into targets. To start the iSCSI service, run:

service iscsi start

When this command is executed, the iSCSI init scripts will automatically log into targets where the node.startup setting is configured as automatic. This is the default value of node.startup for all targets.

To prevent automatic login to a target, set node.startup to manual. To do this, run the following command:

iscsiadm -m node --targetname proper_target_name -p target_IP:port -o update -n node.startup -v manual

Deleting the entire record will also prevent automatic login. To do this, run:

iscsiadm -m node --targetname proper_target_name -p target_IP:port -o delete

To automatically mount a file system from an iSCSI device on the network, add a partition entry for the mount in /etc/fstab with the _netdev option. For example, to automatically mount the iSCSI device sdb to /mount/iscsi during startup, add the following line to /etc/fstab:

/dev/sdb /mnt/iscsi ext3 _netdev 0 0

/dev/sdb /mnt/iscsi ext3 _netdev 0 0

To manually log in to an iSCSI target, use the following command:

iscsiadm -m node --targetname proper_target_name -p target_IP:port -l