35.2. Configuring an iface for Software iSCSI
		As mentioned earlier, an 
iface configuration is required for each network object that will be used to bind a session.
	
		Before
	
		To create an 
iface configuration for software iSCSI, run the following command:
	iscsiadm -m iface -I iface_name --op=new
# iscsiadm -m iface -I iface_name --op=new
		This will create a new empty 
iface configuration with a specified iface_name. If an existing iface configuration already has the same iface_name, then it will be overwritten with a new, empty one.
	
		To configure a specific setting of an 
iface configuration, use the following command:
	iscsiadm -m iface -I iface_name --op=update -n iface.setting -v hw_address
# iscsiadm -m iface -I iface_name --op=update -n iface.setting -v hw_address例 35.4. Set MAC address of iface0
			For example, to set the MAC address (
hardware_address) of iface0 to 00:0F:1F:92:6B:BF, run:
		iscsiadm -m iface -I iface0 --op=update -n iface.hwaddress -v 00:0F:1F:92:6B:BF
# iscsiadm -m iface -I iface0 --op=update -n iface.hwaddress -v 00:0F:1F:92:6B:BF
警告
			Do not use 
default or iser as iface names. Both strings are special values used by iscsiadm for backward compatibility. Any manually-created iface configurations named default or iser will disable backwards compatibility.