红帽全球峰会此内容没有您所选择的语言版本。
A.2. TCP Default and Recommended Values
To learn more about JGroups and using TCP and UDP, see Section 26.2, “Configure JGroups (Library Mode)”.
Note
- Values in
JGroups Default Valueindicate values that are configured internally to JGroups, but may be overridden by a custom configuration file or by a JGroups configuration file shipped with JBoss Data Grid. - Values in
JBoss Data Grid Configured Valuesindicate values that are in use by default when using one of the configuration files for JGroups as shipped with JBoss Data Grid. It is recommended to use these values when custom configuration files for JGroups are in use with JBoss Data Grid.
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| bind_addr | Any non-loopback | Set address on specific interface |
| bind_port | Any free port | Set specific port |
| loopback | true | Same as default |
| port_range | 50 | Set based on desired range of ports |
| recv_buf_size | 150,000 | Same as default |
| send_buf_size | 150,000 | 640,000 |
| use_send_queues | true | Same as default |
| sock_conn_timeout | 2,000 | 300 |
| max_bundle_size | 64,000 | 64,000 |
| enable_diagnostics | true | false |
| thread_pool.enabled | true | Same as default |
| thread_pool.min_threads | 2 | This should equal the number of nodes |
| thread_pool.max_threads | 30 | This should be higher than thread_pool.min_threads. For example, for a smaller grid (2-10 nodes), set this value to twice the number of nodes, but for a larger grid (20 or more nodes), the ratio should be lower. As an example, if a grid contains 20 nodes, set this value to 25 and if the grid contains 100 nodes, set the value to 110. |
| thread_pool.keep_alive_time | 30,000 | 60,000 |
| thread_pool.queue_enabled | true | false |
| thread_pool.queue_max_size | 500 | None, queue should be disabled |
| thread_pool.rejection_policy | Discard | Same as default |
| internal_thread_pool.enabled | true | Same as default |
| internal_thread_pool.min_threads | 2 | 5 |
| internal_thread_pool.max_threads | 4 | 20 |
| internal_thread_pool.keep_alive_time | 30,000 | 60,000 |
| internal_thread_pool.queue_enabled | true | false |
| internal_thread_pool.rejection_policy | Discard | Abort |
| oob_thread_pool.enabled | true | Same as default |
| oob_thread_pool.min_threads | 2 | 20 or higher |
| oob_thread_pool.max_threads | 10 | 200 or higher, depending on the load |
| oob_thread_pool.keep_alive_time | 30,000 | 60,000 |
| oob_thread_pool.queue_enabled | true | false |
| oob_thread_pool.queue_max_size | 500 | None, queue should be disabled |
| oob_thread_pool.rejection_policy | Discard | Same as default |
Note
Red Hat JBoss Data Grid 6.5 uses JGroups 3.6.3, in which the TCPPING timeout value is removed and the
pbcast.GMS join_timeout value indicates the timeout period instead.
Recommended Values for S3_PING
See Section 27.2, “S3_PING Configuration Options” for details about configuring S3_PING for JBoss Data Grid.
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| bind_addr | Any non-loopback | Set address on specific interface |
| break_on_coord_rsp | true | Same as default |
| mcast_addr | 230.5.6.7 | Same as default |
| mcast_port | 7555 | Same as default |
| ip_ttl | 8 | 2 |
Note
In JGroups 3.6.1, the MPING timeout value is removed and the
pbcast.GMS join_timeout value indicates the timeout period instead.
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| min_interval | 1,000 | 10,000 |
| max_interval | 10,000 | 30,000 |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| client_bind_por | 0 (randomly selects a port and uses it) | Same as default |
| get_cache_timeout | 1000 milliseconds | Same as default |
| keep_alive | true | Same as default |
| num_tries | 3 | Same as default |
| start_port | 0 (randomly selects a port and uses it) | Same as default |
| suspect_msg_interval | 5000 milliseconds. | Same as default |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| timeout | 40,000 | 60,000. The FD_ALL timeout value is set to two times the longest possible stop the world garbage collection pause in the CMS garbage collector. In a well-tuned JVM, the longest pause is proportional to heap size and should not exceed 1 second per GB of heap. For example, an 8GB heap should not have a pause longer than 8 seconds, so the FD_ALL timeout value must be set to 16 seconds. If longer garbage collection pauses are used, then this timeout value should be increased to avoid false failure detection on a node. |
| interval | 8,000 | 15,000. The FD_ALL interval value must be at least four times smaller than the value set for FD_ALL's timeout value. |
| timeout_check_interval | 2,000 | 5,000 |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| check_timeout | 3,000 | 5,000 |
| cmd | InetAddress.isReachable() (ICMP ping) | - |
| interval | 20,000 | 15,000. The interval value for FD_HOST must be four times smaller than FD_HOST's timeout value. |
| timeout | 60,000 | 60,000. |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| timeout | 2,000 | 5,000 |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| use_mcast_xmit | true | false |
| xmit_interval | 1,000 | Same as default |
| xmit_table_num_rows | 50 | 50 |
| xmit_table_msgs_per_row | 10,000 | 1,024 |
| xmit_table_max_compaction_time | 10,000 | 30,000 |
| max_msg_batch_size | 100 | Same as default |
| resend_last_seqno | false | true |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| xmit_interval | 500 | Same as default |
| xmit_table_num_rows | 100 | 50 |
| xmit_table_msgs_per_row | 1,0000 | 1,024 |
| xmit_table_max_compaction_time | 600,000 | 30,000 |
| max_msg_batch_size | 500 | 100 |
| conn_close_timeout | 60,000 | No recommended value. |
| conn_expiry_timeout | 120,000 | 0 |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| stability_delay | 6,000 | 500 |
| desired_avg_gossip | 20,000 | 5,000 |
| max_bytes | 2,000,000 | 1,000,000 |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| print_local_addr | true | false |
| join_timeout | 5,000 | 15,000 |
| view_bundling | true | Same as default |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| max_credits | 500,000 | 2,000,000 |
| min_threshold | 0.40 | Same as default |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| frag_size | 60,000 | Same as default |
| Parameter | JGroups Default Value | JBoss Data Grid Configured Values |
|---|---|---|
| asymAlgorithm | RSA | - |
| asymInit | 512 | - |
| asymProvider | Bouncy Castle Provider | - |
| changeKeysOnViewChange | false | - |
| symAlgorithm | AES | - |
| symInit | 128 | - |
| symProvider | Bouncy Castle Provider | - |
Note
See the Red Hat JBoss Data Grid Developer Guide's JGroups ENCRYPT section for details.
Recommended Values for SASL
See the Red Hat JBoss Data Grid Developer Guide's User Authentication over Hot Rod Using SASL section for details.
Recommended Values for RELAY2
See Chapter 30, Set Up Cross-Datacenter Replication for details.
'%20d='M201.5%20305.5c-13.8%200-24.9-11.1-24.9-24.6%200-13.8%2011.1-24.9%2024.9-24.9%2013.6%200%2024.6%2011.1%2024.6%2024.9%200%2013.6-11.1%2024.6-24.6%2024.6zM504%20256c0%20137-111%20248-248%20248S8%20393%208%20256%20119%208%20256%208s248%20111%20248%20248zm-132.3-41.2c-9.4%200-17.7%203.9-23.8%2010-22.4-15.5-52.6-25.5-86.1-26.6l17.4-78.3%2055.4%2012.5c0%2013.6%2011.1%2024.6%2024.6%2024.6%2013.8%200%2024.9-11.3%2024.9-24.9s-11.1-24.9-24.9-24.9c-9.7%200-18%205.8-22.1%2013.8l-61.2-13.6c-3-.8-6.1%201.4-6.9%204.4l-19.1%2086.4c-33.2%201.4-63.1%2011.3-85.5%2026.8-6.1-6.4-14.7-10.2-24.1-10.2-34.9%200-46.3%2046.9-14.4%2062.8-1.1%205-1.7%2010.2-1.7%2015.5%200%2052.6%2059.2%2095.2%20132%2095.2%2073.1%200%20132.3-42.6%20132.3-95.2%200-5.3-.6-10.8-1.9-15.8%2031.3-16%2019.8-62.5-14.9-62.5zM302.8%20331c-18.2%2018.2-76.1%2017.9-93.6%200-2.2-2.2-6.1-2.2-8.3%200-2.5%202.5-2.5%206.4%200%208.6%2022.8%2022.8%2087.3%2022.8%20110.2%200%202.5-2.2%202.5-6.1%200-8.6-2.2-2.2-6.1-2.2-8.3%200zm7.7-75c-13.6%200-24.6%2011.1-24.6%2024.9%200%2013.6%2011.1%2024.6%2024.6%2024.6%2013.8%200%2024.9-11.1%2024.9-24.6%200-13.8-11-24.9-24.9-24.9z'/%3e%3c/svg%3e){kind=small}