此内容没有您所选择的语言版本。
4.3. IPMI Fence Device Configuration Procedure
This section provides the procedure for adding an IPMI fence device to each node of cluster
ipmiclust
. Each node of ipmiclust
is managed by its own IPMI management board.
Use the following procedure to configure the IPMI management board as the fence device for node
clusternode1.example.com
using Conga:
- As an administrator of luci Select the cluster tab. This displays the Choose a cluster to administer screen.
- From the Choose a cluster to administer screen, you should see the previously configured cluster
ipmiclust
displayed, along with the nodes that make up the cluster. Click on . This displays the configuration screen for nodeclusternode1.example.com
. - At the
Main Fencing Method
display, click . This causes a dropdown manu to display. - From the dropdown menu, under Figure 4.2, “Creating an IPMI Fence Device”., select . This displays a fence device configuration menu, as shown in
Figure 4.2. Creating an IPMI Fence Device
- For, enter
ipmifence1
. - For, enter
10.15.86.96
. - For, enter
ipmilogin
. - For, enter
ipmipword
. - For, leave the field blank.
- For, enter
password
. This field specifies the IPMI authentication type. Possible values for this field are none,password
,md2
, ormd5
. - Leave thefield blank. You would check this field if your fence device is a Lanplus-capable interface such as iLO2.
- Click. This causes a confirmation screen to be displayed.
- On the confirmation screen, click. After the fence device has been added, a progress page is displayed after which the display returns to the configuration page for
clusternode1.example.com
in clusteripmiclust
.
After configuring an IPMI fence device for
clusternode1.example.com
, use the following procedure to configure an IPMI fence device for clusternode2.example.com
.
- From the configuration page for
clusternode1.example.com
, a menu appears on the left of the screen for clusteripmiclust
. Select the nodeclusternode2.example.com
. The configuration page forclusternode2.example.com
appears, with no fence device configured. - At the
Main Fencing Method
display, click . This causes a dropdown manu to display. - From the dropdown menu, under, select . This displays a fence device configuration menu.
- For, enter
ipmifence2
. - For, enter
10.15.86.97
. - For, enter
ipmilogin
. - For, enter
ipmipword
. - For, leave the field blank.
- For, enter
password
. This field specifies the IPMI authentication type. Possible values for this field are none,password
,md2
, ormd5
. - Leave thefield blank.
- Click. This causes a confirmation screen to be displayed.
- On the confirmation screen, click. After the fence device has been added, a progress page is displayed after which the display returns to the configuration page for
clusternode1.example.com
in clusteripmiclust
.
After configuring
ipmifence2
as the fencing device for clusternode2.example.com
, select node clusternode3.example.com
from the menu on the left side of the page and configure an IPMI fence device for that node using the same procedure as you did to configure the fence devices for clusternode2.example.com
and clusternode3.example.com
. For clusternode3.example.com
, use ipmifence3
as the name of the fencing method and 10.15.86.98 as the IP address. Otherwise, use the same values for the fence device parameters.