9.6. Starting and Stopping NFS

To run an NFS server, the rpcbind^[3] service must be running. To verify that rpcbind is active, use the following command:

    # service rpcbind status

If the rpcbind service is running, then the nfs service can be started. To start an NFS server, use the following command:

    # service nfs start

nfslock must also be started for both the NFS client and server to function properly. To start NFS locking, use the following command:

    # service nfslock start

If NFS is set to start at boot, ensure that nfslock also starts by running chkconfig --list nfslock. If nfslock is not set to on, this implies that you will need to manually run the service nfslock start each time the computer starts. To set nfslock to automatically start on boot, use chkconfig nfslock on.

nfslock is only needed for NFSv2 and NFSv3.

To stop the server, use:

    # service nfs stop

The restart option is a shorthand way of stopping and then starting NFS. This is the most efficient way to make configuration changes take effect after editing the configuration file for NFS. To restart the server type:

    # service nfs restart

The condrestart (conditional restart) option only starts nfs if it is currently running. This option is useful for scripts, because it does not start the daemon if it is not running. To conditionally restart the server type:

    # service nfs condrestart

To reload the NFS server configuration file without restarting the service type:

    # service nfs reload