8.5. Starting and Stopping the NFS Server

Prerequisites

For servers that support NFSv2 or NFSv3 connections, the rpcbind^[1] service must be running. To verify that rpcbind is active, use the following command:
```
systemctl status rpcbind
```
```
$ systemctl status rpcbind
```
Copy to Clipboard Toggle word wrap
To configure an NFSv4-only server, which does not require rpcbind, see Section 8.6.7, “Configuring an NFSv4-only Server”.
On Red Hat Enterprise Linux 7.0, if your NFS server exports NFSv3 and is enabled to start at boot, you need to manually start and enable the nfs-lock service:
```
systemctl start nfs-lock
systemctl enable nfs-lock
```
```
# systemctl start nfs-lock
# systemctl enable nfs-lock
```
Copy to Clipboard Toggle word wrap
On Red Hat Enterprise Linux 7.1 and later, nfs-lock starts automatically if needed, and an attempt to enable it manually fails.

Procedures

To start an NFS server, use the following command:
```
systemctl start nfs
```
```
# systemctl start nfs
```
Copy to Clipboard Toggle word wrap
To enable NFS to start at boot, use the following command:
```
systemctl enable nfs
```
```
# systemctl enable nfs
```
Copy to Clipboard Toggle word wrap
To stop the server, use:
```
systemctl stop nfs
```
```
# systemctl stop nfs
```
Copy to Clipboard Toggle word wrap
The restart option is a shorthand way of stopping and then starting NFS. This is the most efficient way to make configuration changes take effect after editing the configuration file for NFS. To restart the server type:
```
systemctl restart nfs
```
```
# systemctl restart nfs
```
Copy to Clipboard Toggle word wrap
After you edit the /etc/sysconfig/nfs file, restart the nfs-config service by running the following command for the new values to take effect:
```
systemctl restart nfs-config
```
```
# systemctl restart nfs-config
```
Copy to Clipboard Toggle word wrap
The try-restart command only starts nfs if it is currently running. This command is the equivalent of condrestart (conditional restart) in Red Hat init scripts and is useful because it does not start the daemon if NFS is not running.
To conditionally restart the server, type:
```
systemctl try-restart nfs
```
```
# systemctl try-restart nfs
```
Copy to Clipboard Toggle word wrap
To reload the NFS server configuration file without restarting the service type:
```
systemctl reload nfs
```
```
# systemctl reload nfs
```
Copy to Clipboard Toggle word wrap

Nach oben

Dieser Inhalt ist in der von Ihnen ausgewählten Sprache nicht verfügbar.

8.5. Starting and Stopping the NFS Server

Prerequisites

Procedures

Lernen

Testen, kaufen und verkaufen

Communitys

Über Red Hat Dokumentation

Mehr Inklusion in Open Source

Über Red Hat

Theme

Red Hat legal and privacy links

Red Hat legal and privacy links