2.7. Securing Virtual Private Networks (VPNs)

download PDF
In Red Hat Enterprise Linux 6, a Virtual Private Network (VPN) can be configured using the IPsec tunneling protocol which is supported by the Libreswan application. Libreswan is a fork of the Openswan application and examples in documentation should be interchangeable. The NetworkManager IPsec plug-in is called NetworkManager-openswan.


Libreswan replaced Openswan as the preferred implementation of IPsec in Red Hat Enterprise Linux 6.8. Performing an upgrade from a version earlier than 6.8 replaces the openswan package with libreswan.
Libreswan is an open-source, user-space IPsec implementation available in Red Hat Enterprise Linux 6. It uses the Internet key exchange (IKE) protocol. IKE version 1 and 2 are implemented as a user-level daemon. Manual key establishment is also possible via ip xfrm commands, however this is not recommended. Libreswan interfaces with the Linux kernel using netlink to transfer the encryption keys. Packet encryption and decryption happen in the Linux kernel.
Libreswan uses the network security services (NSS) cryptographic library, which is required for Federal Information Processing Standard (FIPS) security compliance.

2.7.1. IPsec VPN Using Libreswan

To install Libreswan, issue the following command as root. Note that the libreswan package is available from the Extras repository, which needs to be enabled for the installation to succeed. See How to enable/disable a repository using Red Hat Subscription Manager? (The ID of the Extras repository is rhel-6-server-extras-rpms.)
~]# yum install libreswan
To check that Libreswan is installed, issue the following command:
~]$ yum info libreswan
After a new installation of Libreswan the NSS database should be initialized as part of the install process. However, should you need to start a new database, first remove the old database as follows:
~]# rm /etc/ipsec.d/*db
Then, to initialize a new NSS database, issue the following command as root:
~]# ipsec initnss
Initializing NSS database
See 'man pluto' if you want to protect the NSS database with a password
To start the ipsec daemon provided by Libreswan, issue the following command as root:
~]# service ipsec start
To confirm that the daemon is now running:
~]$ service ipsec status
pluto (pid  3496) is running...
To ensure that Libreswan will start when the system starts, issue the following command as root:
~]# chkconfig ipsec on
Configure any intermediate as well as host-based firewalls to permit the ipsec service. See Section 2.8, “Firewalls” for information on firewalls and allowing specific services to pass through. Libreswan requires the firewall to allow the following packets:
  • UDP port 500 for the Internet Key Exchange (IKE) protocol
  • UDP port 4500 for IKE NAT-Traversal
  • Protocol 50 for Encapsulated Security Payload (ESP) IPsec packets
  • Protocol 51 for Authenticated Header (AH) IPsec packets (uncommon)
We present three examples of using Libreswan to set up an IPsec VPN. The first example is for connecting two hosts together so that they may communicate securely. The second example is connecting two sites together to form one network. The third example is supporting roaming users, known as road warriors in this context.
Red Hat logoGithubRedditYoutubeTwitter


Try, buy, & sell


About Red Hat Documentation

We help Red Hat users innovate and achieve their goals with our products and services with content they can trust.

Making open source more inclusive

Red Hat is committed to replacing problematic language in our code, documentation, and web properties. For more details, see the Red Hat Blog.

About Red Hat

We deliver hardened solutions that make it easier for enterprises to work across platforms and environments, from the core datacenter to the network edge.

© 2024 Red Hat, Inc.