Este contenido no está disponible en el idioma seleccionado.
4.16. The GFS Withdraw Function
The GFS withdraw function is a data integrity feature of GFS file systems in a cluster. If the GFS kernel module detects an inconsistency in a GFS file system following an I/O operation, the file system becomes unavailable to the cluster. The I/O operation stops and the system waits for further I/O operations to stop with an error, preventing further damage. When this occurs, you can stop any other services or applications manually, after which you can reboot and remount the GFS file system to replay the journals. If the problem persists, you can unmount the file system from all nodes in the cluster and perform file system recovery with the
gfs_fsck
command. The GFS withdraw function is less severe than a kernel panic, which would cause another node to fence the node.
An example of an inconsistency that would yield a GFS withdraw is an incorrect block count. When the GFS kernel module deletes a file from a file system, it systematically removes all the data and metadata blocks associated with that file. When it is done, it checks the block count. If the block count is not one (meaning all that is left is the disk inode itself), that indicates a file system inconsistency since the block count did not match the list of blocks found.
You can override the GFS withdraw function by mounting the file system with the
-o errors=panic
option specified. When this option is specified, any errors that would normally cause the system to withdraw cause the system to panic instead. This stops the node's cluster communications, which causes the node to be fenced.
Internally, the GFS2 withdraw function works by having the kernel send a message to the
gfs_controld
daemon requesting withdraw. The gfs_controld
daemon runs the dmsetup
program to place the device mapper error target underneath the filesystem preventing further access to the block device. It then tells the kernel that this has been completed. This is the reason for the GFS2 support requirement to always use a CLVM device under GFS2, since otherwise it is not possible to insert a device mapper target.
The purpose of the device mapper error target is to ensure that all future I/O operations will result in an I/O error that will allow the filesystem to be unmounted in an orderly fashion. As a result, when the withdraw occurs, it is normal to see a number of I/O errors from the device mapper device reported in the system logs.
Occasionally, the withdraw may fail if it is not possible for the
dmsetup
program to insert the error target as requested. This can happen if there is a shortage of memory at the point of the withdraw and memory cannot be reclaimed due to the problem that triggered the withdraw in the first place.
A withdraw does not always mean that there is an error in GFS2. Sometimes the withdraw function can be triggered by device I/O errors relating to the underlying block device. It is highly recommended to check the logs to see if that is the case if a withdraw occurs.