Ce contenu n'est pas disponible dans la langue sélectionnée.
1.2. Prerequisites
Ensure that your environment meets the following requirements:
Important
For production use and high availability, a minimum of three servers per trusted storage pool is required.
For quorum reasons, multi-site clusters with synchronous replication require an odd number of sites (minimum of three) to survive a site failure without manual intervention.
1.2.1. Multi-site Cluster Latency
Ensure the latency of the multi-site cluster is no more than 5ms. Execute the following command on each site to determine the latency with the other site:
# ping -c100 -q site_ip_address/site_hostname
Note
For more information, see KCS#413623.
1.2.2. File System Requirements
XFS - Format the back-end file system using XFS for glusterFS bricks. XFS can journal metadata, resulting in faster crash recovery. The XFS file system can also be defragmented and expanded while mounted and active.
Note
Red Hat assists existing Gluster Storage Software Appliance customers using
ext3 or ext4 to upgrade to a supported version of Red Hat Gluster Storage using the XFS back-end file system.
1.2.3. Logical Volume Manager
Format glusterFS bricks using XFS on the Logical Volume Manager to prepare for the installation.
1.2.4. Network Time Configuration
Synchronize time across all Red Hat Gluster Storage servers using the Network Time Protocol (NTP) or Chrony daemon. For more information about these features see Choosing Between NTP Daemons
1.2.4.1. Configuring time synchronization using Chrony
Note
For Red Hat Enterprise Linux 8, chrony is enabled by default and Network Time Protocol (NTP) is no longer supported.
For information on configuring chrony for time synchronization for all Gluster nodes, see Migrating to chrony.
After configuring chrony, verify that time is synchronized for all Gluster nodes by using the following command from the primary node to all other nodes:
# clockdiff node-hostname
1.2.4.2. Configuring time synchronization using Network Time Protocol
For Red Hat Enterprise Linux 7
Use a remote server over the Network Time Protocol (NTP) to synchronize the system clock. For more information on NTP, refer to Configuring NTP Using ntpd. Set the
ntpd daemon to automatically synchronize the time during the boot process as follows:
- Edit the NTP configuration file
/etc/ntp.confusing a text editor such as vim or nano.# nano /etc/ntp.conf
- Add or edit the list of public NTP servers in the
ntp.conffile as follows:server 0.rhel.pool.ntp.org server 1.rhel.pool.ntp.org server 2.rhel.pool.ntp.org
The Red Hat Enterprise Linux 6 version of this file already contains the required information. Edit the contents of this file if customization is required. For more information regarding supported Red Hat Enterprise Linux version for a particular Red Hat Gluster Storage release, see Section 1.7, “Red Hat Gluster Storage Support Matrix”. - Optionally, increase the initial synchronization speed by appending the
iburstdirective to each line:server 0.rhel.pool.ntp.org iburst server 1.rhel.pool.ntp.org iburst server 2.rhel.pool.ntp.org iburst
- After the list of servers is complete, set the required permissions in the same file. Ensure that only
localhosthas unrestricted access:restrict default kod nomodify notrap nopeer noquery restrict -6 default kod nomodify notrap nopeer noquery restrict 127.0.0.1 restrict -6 ::1
- Save all changes, exit the editor, and restart the NTP daemon:
# service ntpd restart
- Ensure that the
ntpddaemon starts at boot time:# chkconfig ntpd on
Use the
ntpdate command for a one-time synchronization of NTP. For more information about this feature, see the Red Hat Enterprise Linux Deployment Guide.
