Chapter 2. Configuring the core RDMA subsystem

Verification

1. Install the libibverbs-utils and infiniband-diags packages:

   # dnf install libibverbs-utils infiniband-diags

2. List the available InfiniBand devices:

   # ibv_devices
   
       device                 node GUID
       ------              ----------------
       mlx4_0              0002c903003178f0
       mlx4_1              f4521403007bcba0

3. Display the information of the mlx4_1 device:

   # ibv_devinfo -d mlx4_1
   
   hca_id: mlx4_1
        transport:                  InfiniBand (0)
        fw_ver:                     2.30.8000
        node_guid:                  f452:1403:007b:cba0
        sys_image_guid:             f452:1403:007b:cba3
        vendor_id:                  0x02c9
        vendor_part_id:             4099
        hw_ver:                     0x0
        board_id:                   MT_1090120019
        phys_port_cnt:              2
             port:   1
                   state:              PORT_ACTIVE (4)
                   max_mtu:            4096 (5)
                   active_mtu:         2048 (4)
                   sm_lid:             2
                   port_lid:           2
                   port_lmc:           0x01
                   link_layer:         InfiniBand
   
             port:   2
                   state:              PORT_ACTIVE (4)
                   max_mtu:            4096 (5)
                   active_mtu:         4096 (5)
                   sm_lid:             0
                   port_lid:           0
                   port_lmc:           0x00
                   link_layer:         Ethernet

4. Display the status of the mlx4_1 device:

   # ibstat mlx4_1
   
   CA 'mlx4_1'
        CA type: MT4099
        Number of ports: 2
        Firmware version: 2.30.8000
        Hardware version: 0
        Node GUID: 0xf4521403007bcba0
        System image GUID: 0xf4521403007bcba3
        Port 1:
              State: Active
              Physical state: LinkUp
              Rate: 56
              Base lid: 2
              LMC: 1
              SM lid: 2
              Capability mask: 0x0251486a
              Port GUID: 0xf4521403007bcba1
              Link layer: InfiniBand
        Port 2:
              State: Active
              Physical state: LinkUp
              Rate: 40
              Base lid: 0
              LMC: 0
              SM lid: 0
              Capability mask: 0x04010000
              Port GUID: 0xf65214fffe7bcba2
              Link layer: Ethernet

5. The ibping utility pings an InfiniBand address and runs as a client/server by configuring the parameters.

   1. Start server mode -S on port number -P with -C InfiniBand channel adapter (CA) name on the host:

      # ibping -S -C mlx4_1 -P 1

   2. Start client mode, send some packets -c on port number -P by using -C InfiniBand channel adapter (CA) name with -L Local Identifier (LID) on the host:

      # ibping -c 50 -C mlx4_0 -P 1 -L 2