Questo contenuto non è disponibile nella lingua selezionata.
15.2. Removing Swap Space
Sometimes it can be prudent to reduce swap space after installation. For example, you have downgraded the amount of RAM in your system from 1 GB to 512 MB, but there is 2 GB of swap space still assigned. It might be advantageous to reduce the amount of swap space to 1 GB, since the larger 2 GB could be wasting disk space.
You have three options: remove an entire LVM2 logical volume used for swap, remove a swap file, or reduce swap space on an existing LVM2 logical volume.
15.2.1. Reducing Swap on an LVM2 Logical Volume
To reduce an LVM2 swap logical volume (assuming
/dev/VolGroup00/LogVol01 is the volume you want to reduce):
Procedure 15.3. Reducing an LVM2 Swap Logical Volume
- Disable swapping for the associated logical volume:
#
swapoff -v /dev/VolGroup00/LogVol01 - Reduce the LVM2 logical volume by 512 MB:
#
lvreduce /dev/VolGroup00/LogVol01 -L -512M - Format the new swap space:
#
mkswap /dev/VolGroup00/LogVol01 - Activate swap on the logical volume:
#
swapon -v /dev/VolGroup00/LogVol01 - To test if the swap logical volume was successfully reduced, inspect active swap space:
$
cat /proc/swaps$free -h
15.2.2. Removing an LVM2 Logical Volume for Swap
To remove a swap volume group (assuming
/dev/VolGroup00/LogVol02 is the swap volume you want to remove):
Procedure 15.4. Remove a Swap Volume Group
- Disable swapping for the associated logical volume:
#swapoff -v /dev/VolGroup00/LogVol02 - Remove the LVM2 logical volume:
#lvremove /dev/VolGroup00/LogVol02 - Remove the following associated entry from the
/etc/fstabfile:/dev/VolGroup00/LogVol02 swap swap defaults 0 0
- Regenerate mount units so that your system registers the new configuration:
#systemctl daemon-reload - Remove all references to the removed swap storage from the
/etc/default/grubfile:#vi /etc/default/grub - Rebuild the grub configuration:
- on BIOS-based machines, run:
#grub2-mkconfig -o /boot/grub2/grub.cfg - on UEFI-based machines, run:
#grub2-mkconfig -o /boot/efi/EFI/redhat/grub.cfg
- To test if the logical volume was successfully removed, inspect active swap space:
$
cat /proc/swaps$free -h
15.2.3. Removing a Swap File
To remove a swap file:
Procedure 15.5. Remove a Swap File
- At a shell prompt, execute the following command to disable the swap file (where
/swapfileis the swap file):#
swapoff -v /swapfile - Remove its entry from the
/etc/fstabfile. - Regenerate mount units so that your system registers the new configuration:
#systemctl daemon-reload - Remove the actual file:
#
rm /swapfile
