このコンテンツは選択した言語では利用できません。
4.3.6. Changing the Parameters of a Volume Group
The
vgchange command is used to deactivate and activate volume groups, as described in Section 4.3.7, “Activating and Deactivating Volume Groups”. You can also use this command to change several volume group parameters for an existing volume group.
The following command changes the maximum number of logical volumes of volume group
vg00 to 128.
vgchange -l 128 /dev/vg00
For a description of the volume group parameters you can change with the
vgchange command, see the vgchange(8) man page.
