此内容没有您所选择的语言版本。
5.6.3. Removing a Member from a Failover Domain
To remove a member from a failover domain, follow these steps:
- At the left frame of the the Cluster Configuration Tool, click the failover domain that you want to change (listed under ).
- At the bottom of the right frame (labeled ), click the button. Clicking the button causes the Failover Domain Configuration dialog box to be displayed (Figure 5.10, “: Configuring a Failover Domain”).
- At the Failover Domain Configuration dialog box, in the column, click the node name that you want to delete from the failover domain and click the button. Clicking removes the node from the column. Repeat this step for each node that is to be deleted from the failover domain. (Nodes must be deleted one at a time.)
- When finished, click .
- At the Cluster Configuration Tool, perform one of the following actions depending on whether the configuration is for a new cluster or for one that is operational and running:
- New cluster — If this is a new cluster, choose => to save the changes to the cluster configuration.
- Running cluster — If this cluster is operational and running, and you want to propagate the change immediately, click the button. Clicking automatically saves the configuration change. If you do not want to propagate the change immediately, choose => to save the changes to the cluster configuration.
