38.6. 使用附加 FCP 的 SCSI DVD 驱动器在 LPAR 中安装
这需要一个连接到 FCP-to-SCSI 桥的 SCSI DVD 驱动器,该桥又连接到您系统 Z 机器中的 FCP 适配器。必须配置这个 FCP 适配器并使其可用。
流程
- 将用于 64 位 IBM Z 的 Red Hat Enterprise Linux DVD 插入到 DVD 驱动器中。
- 双击 Load。
- 在随后的对话框中,选择 SCSI 作为 Load type。
- 在 Load address 中,填写连接到 FCP-to-SCSI 桥接的 FCP 频道的设备号。
- 在 World wide port name 中输入 16 位十六进制数字作为 FCP-to-SCSI 桥接的 WWPN。
- 在 Logical unit number 中输入 16 位十六进制数字作为 DVD 驱动器的 LUN。
- 作为 Boot program selector ,输入数字 1,来在用于 64 位 IBM Z 的 Red Hat Enterprise Linux DVD 中选择引导条目。
- 将 Boot record logical block address 设置为 0,Operating system specific load parameters 为空。
- 点确定按钮。