Chapter 3. Deploying an Overcloud with the Bare Metal Service

Use an environment file to deploy the overcloud with the Bare Metal service enabled. A template is located on the director node at /usr/share/openstack-tripleo-heat-templates/environments/services/ironic.yaml.

For a full list of configuration parameters, see the section Bare Metal in the Overcloud Parameters guide.

Create a bridge called br-baremetal for ironic to use. You can specify this in an additional template:

~/templates/network-environment.yaml

parameter_defaults:
  NeutronBridgeMappings: datacentre:br-ex,baremetal:br-baremetal
  NeutronFlatNetworks: datacentre,baremetal

You can either configure this bridge in the provisioning network (control plane) of the controllers, so you can reuse this network as the bare metal network, or add a dedicated network. The configuration requirements are the same, however the bare metal network cannot be VLAN-tagged, as it is used for provisioning.

~/templates/nic-configs/controller.yaml

network_config:
    -
      type: ovs_bridge
          name: br-baremetal
          use_dhcp: false
          members:
            -
              type: interface
              name: eth1

The following is an example template file. This file may not meet the requirements of your environment. Before using this example, make sure it does not interfere with any existing configuration in your environment.

~/templates/ironic.yaml

parameter_defaults:

    NovaSchedulerDefaultFilters:
        - RetryFilter
        - AggregateInstanceExtraSpecsFilter
        - AvailabilityZoneFilter
        - RamFilter
        - DiskFilter
        - ComputeFilter
        - ComputeCapabilitiesFilter
        - ImagePropertiesFilter

    IronicCleaningDiskErase: metadata

In this example:

To enable the Bare Metal service, include your ironic environment files with -e when deploying or redeploying the overcloud, along with the rest of your overcloud configuration.

For example:

$ openstack overcloud deploy \
  --templates \
  -e ~/templates/node-info.yaml \
  -e /usr/share/openstack-tripleo-heat-templates/environments/network-isolation.yaml \
  -e ~/templates/network-environment.yaml \
  -e /usr/share/openstack-tripleo-heat-templates/environments/services/ironic.yaml \
  -e ~/templates/ironic.yaml \

For more information about deploying the overcloud, see Creating the Overcloud with the CLI Tools and Including Environment Files in Overcloud Creation.

You can use the OpenStack Integration Test Suite to validate your Red Hat OpenStack deployment. For more information, see the OpenStack Integration Test Suite Guide.