Red Hat SummitEste contenido no está disponible en el idioma seleccionado.
2.46. xen
Xen is a high-performance and secure open-source virtualization framework. The virtualization allows users to run guest operating systems in virtual machines on top of a host operating system.
- In some cases, Red Hat Enterprise Linux 6 guests running fully-virtualized under Red Hat Enterprise Linux 5 experience a time drift or fail to boot. In some cases, drifting may start after migration of the virtual machine to a host with different speed. This is due to limitations in the Red Hat Enterprise Linux 5 Xen Hypervisor. To work around this, add
clocksource=acpi_pmorclocksource=jiffiesto the kernel command line for the guest. Alternatively, if running under Red Hat Enterprise Linux 5.7 or newer, locate the guest configuration file for the guest and add thehpet=0option in it. - There are only 2 virtual slots (00:06.0 and 00:07.0) that are available for hot plug support in a virtual guest. (BZ#564261)
- As of Red Hat Enterprise Linux 5.4, PCI devices connected to a single PCI-PCI bridge can no longer be assigned to different PV guests. If the old, unsafe behavior is required, disable pci-dev-assign-strict-check in /etc/xen/xend-config.sxp. (BZ#508310)
- When running x86_64 Xen, it is recommended to set dom0-min-mem in /etc/xen/xend-config.sxp to a value of 1024 or higher. Lower values may cause the dom0 to run out of memory, resulting in poor performance or out-of-memory situations. (BZ#519492)
- The Red Hat Enterprise Linux 3 kernel does not include SWIOTLB support. SWIOTLB support is required for Red Hat Enterprise Linux 3 guests to support more than 4GB of memory on AMD Opteron and Athlon-64 processors. Consequently, Red Hat Enterprise Linux 3 guests are limited to 4GB of memory on AMD processors. (BZ#504187)
- The Hypervisor outputs messages regarding attempts by any guest to write to an MSR. Such messages contain the statement
Domain attempted WRMSR. These messages can be safely ignored; furthermore, they are rate limited and should pose no performance risk. (BZ#477647)
The following known issues applies to the Intel 64 and AMD64 architectures:
- Installing Red Hat Enterprise Linux 3.9 on a fully virtualized guest may be extremely slow. In addition, booting up the guest after installation may result in
hda: lost interrupterrors.To avoid this bootup error, configure the guest to use the SMP kernel. (BZ#249521)
'%20d='M201.5%20305.5c-13.8%200-24.9-11.1-24.9-24.6%200-13.8%2011.1-24.9%2024.9-24.9%2013.6%200%2024.6%2011.1%2024.6%2024.9%200%2013.6-11.1%2024.6-24.6%2024.6zM504%20256c0%20137-111%20248-248%20248S8%20393%208%20256%20119%208%20256%208s248%20111%20248%20248zm-132.3-41.2c-9.4%200-17.7%203.9-23.8%2010-22.4-15.5-52.6-25.5-86.1-26.6l17.4-78.3%2055.4%2012.5c0%2013.6%2011.1%2024.6%2024.6%2024.6%2013.8%200%2024.9-11.3%2024.9-24.9s-11.1-24.9-24.9-24.9c-9.7%200-18%205.8-22.1%2013.8l-61.2-13.6c-3-.8-6.1%201.4-6.9%204.4l-19.1%2086.4c-33.2%201.4-63.1%2011.3-85.5%2026.8-6.1-6.4-14.7-10.2-24.1-10.2-34.9%200-46.3%2046.9-14.4%2062.8-1.1%205-1.7%2010.2-1.7%2015.5%200%2052.6%2059.2%2095.2%20132%2095.2%2073.1%200%20132.3-42.6%20132.3-95.2%200-5.3-.6-10.8-1.9-15.8%2031.3-16%2019.8-62.5-14.9-62.5zM302.8%20331c-18.2%2018.2-76.1%2017.9-93.6%200-2.2-2.2-6.1-2.2-8.3%200-2.5%202.5-2.5%206.4%200%208.6%2022.8%2022.8%2087.3%2022.8%20110.2%200%202.5-2.2%202.5-6.1%200-8.6-2.2-2.2-6.1-2.2-8.3%200zm7.7-75c-13.6%200-24.6%2011.1-24.6%2024.9%200%2013.6%2011.1%2024.6%2024.6%2024.6%2013.8%200%2024.9-11.1%2024.9-24.6%200-13.8-11-24.9-24.9-24.9z'/%3e%3c/svg%3e){kind=small}