Ce contenu n'est pas disponible dans la langue sélectionnée.
28.5.4. Testing ABRT's Crash Detection
After completing all the steps of the configuration process, the basic setup is finished. To test that this setup works properly use the
kill -s SEGV PID
command to terminate a process on a client system. For example, start a sleep
process and terminate it with the kill
command in the following way:
~]$sleep 100 &
[1] 2823 ~]$kill -s SIGSEGV 2823
ABRT should detect a crash shortly after executing the
kill
command. Check that the crash was detected by ABRT on the client system (this can be checked by examining the appropriate syslog file, by running the abrt-cli list --full
command, or by examining the crash dump created in the /var/spool/abrt
directory), copied to the server system, unpacked on the server system and can be seen and acted upon using abrt-cli
or abrt-gui
on the server system.