Ce contenu n'est pas disponible dans la langue sélectionnée.
27.2.2. Running the At Service
The At and Batch jobs are both picked by the
atd service. This section provides information on how to start, stop, and restart the atd service, and shows how to enable it in a particular runlevel. For more information on the concept of runlevels and how to manage system services in Red Hat Enterprise Linux in general, see Chapter 12, Services and Daemons.
27.2.2.1. Starting and Stopping the At Service
To determine if the service is running, use the command
service atd status.
To run the
atd service in the current session, type the following at a shell prompt as root:
serviceatdstart
To configure the service to start automatically at boot, use the following command:
chkconfigatdon
Note
It is recommended to start the service at boot automatically.
This command enables the service in runlevel 2, 3, 4, and 5. Alternatively, you can use the Service Configuration utility as described in Section 12.2.1.1, “Enabling and Disabling a Service”.
27.2.2.2. Stopping the At Service
To stop the
atd service, type the following at a shell prompt as root
serviceatdstop
To disable starting the service at boot time, use the following command:
chkconfigatdoff
This command disables the service in all runlevels. Alternatively, you can use the Service Configuration utility as described in Section 12.2.1.1, “Enabling and Disabling a Service”.
27.2.2.3. Restarting the At Service
To restart the
atd service, type the following at a shell prompt:
serviceatdrestart
This command stops the service and starts it again in quick succession.
