このコンテンツは選択した言語では利用できません。
3.9. Adding a Cluster Service to the Cluster
To add a cluster service to the cluster, follow the steps in this section. The starting point of the procedure is at the cluster-specific page that you navigate to from Choose a cluster to administer displayed on the tab.
- At the detailed menu for the cluster (below the menu), click . Clicking causes the display of services in the center of the page and causes the display of menu items for services configuration: and .
- Click . Clicking causes the Add a Service page to be displayed.
- On the Add a Service page, at the text box, type the name of the service. Below the text box is an checkbox labeled . The checkbox is checked by default. When the checkbox is checked, the service is started automatically when a cluster is started and running. If the checkbox is not checked, the service must be started manually any time the cluster comes up from the stopped state.
Note
Use a descriptive name that clearly distinguishes the service from other services in the cluster. - Add a resource to the service; click . Clicking causes the display of two drop-down boxes: and . Adding a new local resource adds a resource that is available only to this service. The process of adding a local resource is the same as adding a global resource described in Section 3.8, “Adding Cluster Resources”. Adding a global resource adds a resource that has been previously added as a global resource (refer to Section 3.8, “Adding Cluster Resources”).
- At the drop-down box of either or , select the resource to add and configure it according to the options presented. (The options are the same as described in Section 3.8, “Adding Cluster Resources”.)
Note
If you are adding a Samba-service resource, connect a Samba-service resource directly to the service, not to a resource within a service. - If you want to add resources to that resource, click . Clicking causes the display of additional options to local and global resources. You can continue adding children resources to the resource to suit your requirements. To view children resources, click the triangle icon to the left of .
- When you have completed adding resources to the service, and have completed adding children resources to resources, click . Clicking causes a progress page to be displayed followed by a page displaying the added service (and other services).
Note
To verify the existence of the IP service resource used in a cluster service, you must use the
/sbin/ip addr list command on a cluster node. The following output shows the /sbin/ip addr list command executed on a node running a cluster service:
1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP> mtu 1356 qdisc pfifo_fast qlen 1000
link/ether 00:05:5d:9a:d8:91 brd ff:ff:ff:ff:ff:ff
inet 10.11.4.31/22 brd 10.11.7.255 scope global eth0
inet6 fe80::205:5dff:fe9a:d891/64 scope link
inet 10.11.4.240/22 scope global secondary eth0
valid_lft forever preferred_lft forever
