이 콘텐츠는 선택한 언어로 제공되지 않습니다.
3.6. Configuring Cluster Members
Configuring cluster members consists of initially configuring nodes in a newly configured cluster, adding members, and deleting members. The following sections provide procedures for initial configuration of nodes, adding nodes, and deleting nodes:
3.6.1. Initially Configuring Members
Creating a cluster consists of selecting a set of nodes (or members) to be part of the cluster. Once you have completed the initial step of creating a cluster and creating fence devices, you need to configure cluster nodes. To initially configure cluster nodes after creating a new cluster, follow the steps in this section. The starting point of the procedure is at the cluster-specific page that you navigate to from Choose a cluster to administer displayed on the tab.
- At the detailed menu for the cluster (below the menu), click . Clicking causes the display of an element and a element with a list of the nodes already configured in the cluster.
- Click a link for a node at either the list in the center of the page or in the list in the detailed menu under the menu. Clicking a link for a node causes a page to be displayed for that link showing how that node is configured.
- At the bottom of the page, under , click .
- Select a fence device and provide parameters for the fence device (for example port number).
Note
You can choose from an existing fence device or create a new fence device. - Click and wait for the change to take effect.
