Red Hat Summit Red Hat SummitSuporteConsoleDesenvolvedoresComeçar um testeContato

Este conteúdo não está disponível no idioma selecionado.

12.2. Setup

Follow these steps to enable, configure, and start using nested virtualization:
  1. Enable: The feature is disabled by default. To enable it, use the following procedure on the L0 host physical machine.
    For Intel:
    1. Check whether nested virtualization is available on your host system. 
      $ cat /sys/module/kvm_intel/parameters/nested
      If this command returns Y or 1, the feature is enabled.
      If the command returns 0 or N, use steps ii and iii.
    2. Unload the kvm_intel module: 
      # modprobe -r kvm_intel
    3. Activate the nesting feature: 
      # modprobe kvm_intel nested=1
    4. The nesting feature is now enabled only until the next reboot of the L0 host. To enable it permanently, add the following line to the /etc/modprobe.d/kvm.conf file: 
      options kvm_intel nested=1
    For AMD:
    1. Check whether nested virtualization is available on your system: 
      $ cat /sys/module/kvm_amd/parameters/nested
      If this command returns Y or 1, the feature is enabled.
      If the command returns 0 or N, use steps ii and iii.
    2. Unload the kvm_amd module 
      # modprobe -r kvm_amd
    3. Activate the nesting feature 
      # modprobe kvm_amd nested=1
    4. The nesting feature is now enabled only until the next reboot of the L0 host. To enable it permanently, add the following line to the /etc/modprobe.d/kvm.conf file: 
      options kvm_amd nested=1
  2. Configure your L1 virtual machine for nested virtualization using one of the following methods:
    virt-manager
    1. Open the GUI of the intended guest and click the Show Virtual Hardware Details icon.
    2. Select the Processor menu, and in the Configuration section, type host-passthrough in the Model field (do not use the drop-down selection), and click Apply.
    Domain XML
    Add the following line to the domain XML file of the guest: 
    <cpu mode='host-passthrough'/>
    If the guest's XML configuration file already contains a <cpu> element, rewrite it.
  3. To start using nested virtualization, install an L2 guest within the L1 guest. To do this, follow the same procedure as when installing the L1 guest - see Chapter 3, Creating a Virtual Machine for more information.
Red Hat logoGithubredditYoutubeTwitter

Aprender

Experimente, compre e venda

Comunidades

Sobre a documentação da Red Hat

Ajudamos os usuários da Red Hat a inovar e atingir seus objetivos com nossos produtos e serviços com conteúdo em que podem confiar. Explore nossas atualizações recentes.

Tornando o open source mais inclusivo

A Red Hat está comprometida em substituir a linguagem problemática em nosso código, documentação e propriedades da web. Para mais detalhes veja o Blog da Red Hat.

Sobre a Red Hat

Fornecemos soluções robustas que facilitam o trabalho das empresas em plataformas e ambientes, desde o data center principal até a borda da rede.

Theme

© 2026 Red HatVoltar ao topo